Instruction Manual
INSTALLATION
-Please read the safety instructions in this manual completely before installation.
-Install your TV in an area where direct sunlight will not fall upon the screen.
-Soft, indirect light is best for television viewing.
-Allow enough space (at least 4 in.) between the TV and any walls or enclosures for proper ventilation.
-Optimum television viewing distance is
Auto-Degaussing
Color television can be easily affected by magnetism, which shows as color distortion on the screen. If your TV is affected by nearby magnetic components or appliances, turn it off for a few minutes. The
Auto off when no signal received
The TV set will automatically enter into Standby mode when the following conditions are met. 1.TV is in antenna mode.
2.Current channel has no signal.
3.No key is pressed within 15 minutes.
Connecting the Antenna
| ||
VHF | OR | |
UHF | ||
or Cable | ||
| ||
| Antenna adapter | |
| (not supplied) | |
VHF |
| |
| OR | |
| U/V mixer | |
| (not supplied) | |
UHF |
|
Notes:
1.It is recommended that a 75 ohm coaxial cable be used in order to eliminate interference and noise which may occur due to nearby radio transmissions.
2.The antenna cable should not be tied together with other wiring.
3.Set up a lightning rod and check it regularly when an outdoor antenna is used.
Installing the Remote Conrol Batteries
1.Remove the battery compartment lid.
2.Insert two AAA batteries (included). Make sure the positive (+) and negative
3.Reattach the battery lid.
Notes:
1.Alkaline batteries are recommended for longer life.
2.Always replace both batteries at the same time.
3.Do not expose batteries to fire or break them open.
4.To avoid battery leakage, remove batteries from the remote control when it is not being used for a long period of time.
RF Input
(back of TV unit)
7