Installation

Please read the safety instructions in this manual completely before installation.

Install your TV in a room where direct sunlight will not fall upon the screen.

Allow enough space (at least 10cm) between the TV and the wall for proper ventilation.

It is recommended to watch TV in soft and indirect light. The optimum watching distance is 5-7 times of the screen's vertical length.

Auto-degaussing

Color TV is easily affected by magnetism which leads to color distortion. If your TV is moved or affected by near magnetic components or appliances with power on, press the button to power off your TV for at least 1 hour. The built-in auto-degaussing circuit will eliminate the magnetism interference.

To Connect the Antenna

An outdoor antenna or CATV is recommended for the best reception.

	75-ohm coaxial cable
VHF	OR
UFH	300-ohm twin-lead cable
or Cable	300-ohm twin-lead cable
or Cable
	OR	Antenna adapter
		(not supplied)
VHF

UHF	U/V mixer
	(not supplied)

Notes:

1 It is recommended that a 75 coaxial cable be used in order to eliminate possible interference and noise which may occur due to nearby radio transmissions.

2 The antenna cable should not be tied together with other wiring.

3 Set up a lightning arrester and check it regularly when an outdoor antenna is used.

Remote Batteries

1.Remove the battery compartment lid.

2.Place in two AAA batteries. Make sure the positive + and negative - polarities are correct.

3.Reattach the battery lid.

Notes:

1Alkaline batteries are recommended for longer life. Always replace both batteries with fresh ones of the same type.

2Do not expose batteries to fire or disassemble them.

3To avoid battery leakage, remove batteries from the remote control when it is not to be used for a long period of time or the batteries are exhausted.