Loewe 9272, 9372, 9281 HD Initial installation, Batteries Remote control, Connection, Switching on

Initial installation

Batteries – Remote control

To insert or change the batteries, press the point marked by an embossed arrow. Push the cover of the battery compartment down and remove it. Insert the batteries of the alkaline manganese type LR 03 (AAA) with the correct polarity (+/–).

+

+

Then push the cover back on.

Note on disposal of batteries:

The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collection points according to the national laws. Ask your dealer.

Connection

Mains

Connect the TV set to a 230V/50–60 Hertz outlet.

Antennae

Connect your antenna or cable system to the antenna socket of the PIP tuner.

Plug the antenna plug protruding from above the PIP tuner into the antenna socket of the VHF/UHF tuner.

If your TV set is equipped with a DVB-T module, connect your antenna or cable systems to the top socket of the DVB-T module (IN) and con- nect the bottom socket (OUT) to the antenna input of the PIP tuner. If equipped with one or two satellite tuners, connect the SAT antennae to the SAT sockets (see figure on page 5).

						DIG IN
SAT	RC5/RC6	SERVICE				1
	IR					2
		CTRL
SAT A/D		VGA				DIG OUT
		AUDIO IN	AV1	AV2/RGB	AV3
			R
		AUDIO	OUT
	VHF/UHF		L
						SUR
					C	R
				SUBWOOFER		L
				STAND	SUB

Switching on

The On/Off switch on the TV set is located behind the control panel. Open the flap of the control panel.

Press the On/Off button so that it is pressed in.

Initial installation

Automatic programming of the TV set is started the first time you switch it on. Follow the menus.

First you have to select the menu language for your set. Then you specify which antenna you have connected to your TV and in what country you are using it. Then you start the station search. The TV set searches for, stores and sorts all the stations which your antenna system receives. You then see a list of the stored stations in which you can mark your favorites. Finally log in your video recorders, decoders, Loewe audio system and Home Automation with the connection wizard and connect these to the TV set according to the illustrated connection plan.

	Select the settings with the
	arrows on the ring ...
OK	... confirm the settings with
	OK. You then move on to the
	next menu ...
i	... press this button if you want
	information about the settings.

You can repeat initial installation at any time, e.g. after moving house. Call the index in the main information (i button). Then select the item ”Repeat initial installation”. Then start ”Initial installation” with OK.

9

BAQ2550H_31308_020_3_GB2 9 07.05.2004, 10:58 Uhr