SELECTING THE SIGNAL TO RECORD
You can select the signal to record — from the IN FROM ANT jack or an audio/video source — in either of these ways.
•Repeatedly press INPUT until the desired input source appears — LINE (LINE 1 or LINE 2 on the Model 62) for an audio/ video source, or a channel number for broadcast signals.
•Repeatedly press CH s or CH t to set the VCR to the desired broadcast channel or to one channel higher than the highest chan- nel number (or one channel lower than the lowest channel number) for an audio/video source.
Note: (Model 62 only) Select LINE 1 for re- cording signals from the back AUDIO IN 1/VID- EO IN 1 jacks, or LINE 2 for recording signals from the front AV2 jacks.
RECEIVING/RECORDING STEREO/SAP BROADCASTS (MODEL 62 ONLY)
The Model 62 has three channels for audio re- cording — two (left and right) stereo channels on the
Press DISP/ENT to display the audio programs available on the broadcast you are currently tuned to. STEREO, SAP, and MONO appear. Parenthesis appear around each type of audio signal that is not available. For example, if a station broadcasts mono (monaural) and SAP signals, (STEREO), SAP, and MONO appear.
The arrow mark on the right of the audio mode display indicates the current audio mode. To select the audio mode when the broadcast has a stereo or SAP signal, press
28
IMMEDIATE RECORDING
Recording a Program
as You Watch It
Follow these steps to record a program as you watch it. If you know how long the program is, you can set how long the VCR records so it stops recording automatically.
Note: If you are watching the program on a TV/ monitor that is connected to the VCR’s AUDIO/ VIDEO OUT jacks, set the TV/monitor to the vid- eo mode and skip Steps 2 and 3.
1.Turn on the VCR and the TV.
2.Set the TV’s tuner to the same channel as
3.Press TV/VCR until VCR appears.
4.Load a blank cassette, or one that you want to record over, into the VCR.
5.Repeatedly press SPEED on the remote control until the desired recording speed (SP, LP, or EP) appears.
6.Select the signal to record (see “Selecting the Signal to Record”).
7.(Model 62 only) Set the audio recording mode to the desired setting. See “Receiv- ing/Recording Stereo/SAP Broadcasts (Model 62 Only”).
8.Press REC/TIME. The VCR starts to record and the following appears on the TV screen:
REC 02
TO SET SPECI FI C REC TI ME
PLEASE PUSH REC KEY