Loewe Connect 37 Full-HD+ 100 manual For your safety, Proper use and environmental conditions

For your safety

For your own safety and to prevent unnecessary damage to your device, read and comply with the following safety instructions:

Proper use and environmental conditions

This TV set is intended exclusively for the reception and reproduction of video and audio signals and designed for the home and office. It may not be used in rooms with high humidity (e.g. bathrooms, saunas) or high dust concentration (e.g. workshops). The manufacturer‘s warranty is only valid for use in the specified permissible environment.

If the set is used outdoors then ensure that it is protected against mois- ture (rain, splashing water, or dew). High humidity and dust concentration cause creep currents in the set. This can cause electric shocks or fires.

If you have brought the set into a warm environment from the cold, then wait for about 1 hour before switching it on to avoid formation of con- densation.

Do not place any objects filled with liquid or burning candles on the de- vice. Protect the set against dripping

Power supply

The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and frequency as that specified on the rating plate; use the power cable provided. The mains plug of the TV set must be easily accessible so that the device can be disconnected from the mains at any time. When you unplug the mains plug, do not pull on the cable rather pull on the plug housing. The cable in the mains plug could be damaged and cause a short circuit the next time it is plugged in.

Lay out the power cable in such a manner that it cannot be damaged. The power cable may not be kinked or laid over sharp edges, stepped on or exposed to chemicals; The latter also applies for the entire equip- ment. A power cable with damaged insulation can cause electrical shock and is a fire hazard.

Air circulation and high temperatures

The vent slots on the rear panel of the set must always be kept free. Please do not place newspapers or cloths on/over the TV.

and splashing water.

C Never place the TV set in a position where it is exposed to vibrations. This can lead to material overload.

When rotating the TV set there is a danger of crushing between the TV housing and the table stand. Makes sure that your fingers or other objects

are not in this area when rotating the TV set.

Transporting

At least 10 cm clearance must be left at the sides and top for air circulation if the TV set is placed or hung in a cabinet or a shelf.

Like any electronic device, your TV set requires air for cooling. Ob- struction of the air circulation can cause fires.

The set is suitable for different instal- lation solutions. See the instructions for assembly for the different instal- lation solutions.

MEDIA

10 cm

10 cm

10 cm

Only transport the device in vertical position. Grasp the device on the upper and lower edges of the housing.

The LCD screen is made of glass or plastic and can break if not handled properly.

If the LCD screen is damaged and liquid crystal is leaking, wear rubber gloves for handling the TV set. If there is skin contact immediately wash thoroughly with water.

Downloaded From TV-Manual.com Manuals

Stand the TV set with the table or floor stand only on a level, sturdy, horizontal base. Particularly ensure that the set does not protrude to the front when placed in or on pieces of furniture.

Set up the device where it is not exposed to direct sunlight and where it is not exposed to additional warming through heating elements.

Prevent metal items, needles, paper clips, liquids, wax, or similar items, from getting into the interior of the device through the vent slots in the rear panel. Such objects can cause short circuits in the set, which could possibly cause a fire.

If something should get into the interior of the set then immediately unplug the mains plug of the device and contact customer service for more information.

9 -