P 10/10
Circuit diagram (cont.)
Fig.D-3
Wiring in Motor housing set
1. Place DC motor in Motor housing (L). 2. Fix Lead wires with Line filter
Wire connecting |
| (if used) in these Lead wire holders |
Motor housing (L) | by pushing them in the direction | |
portion of |
| of the arrows. |
Receptacle |
|
|
|
| Lead wire |
|
| (black) |
3.Mount Motor housing (R) to Motor housing (L).
Motor housing (L)
red dot | Line filter | Lead wire | Motor | |
housing (R) | ||||
marking | (if used) | (red) | ||
|
Fig.D-4
Wiring to Terminal
Connected Receptacles to Terminals as drawn below.
Receptacle
Terminal
Receptacle
Fig.D-6
Fig.D-5
Put Controller in Handle (R).
Controller
Handle (R)
Wiring in Handle (R)
Do not route Lead wires over these ribs.
Controller
Connect Receptacles with Lead wires
as drawn on the right.
Lead wire 
(white) 
Switch 
Switch
Handle (R)
Receptacle
Lead wire (red)
Terminal 