Tuning the TV to Your VCR
The VCR supplies a signal to the TV via the RF coaxial cable on channel
It is possible to view the video picture on your TV in the same way that you watch TV broadcasts.
If you have connected the VCR to the TV through the Audio/ Video input sockets, then you do not need to follow the procedure below.
When the VCR is turned on after unpacking and connecting the aerial cable and the mains lead, Plug in Auto Tuning starts automatically.
Notes:
–If the VCR is turned on with the aerial not connected, all channels are skipped. Therefore, firmly connect the aerial and then turn the VCR off and on again to execute Auto Tuning.
–When Auto Tuning is cancelled halfway, Auto Tuning is not executed even if the VCR is turned off and then turned on again. In this case, see page 7 [To Restart Plug in Auto Tuning].
Operations
1Turn on the TV and the VCR.
2Set the TV to an unused position which you wish to use for your video playback.
–Tune the TV until the display shown below appears on the screen. (Please refer to the TV manufacturers operating instructions regarding tuning.)
–Set [RF SELECT] by pressing the Cursor buttons (21)
Sto select the colour TV system used by the TV set to be connected.
BG: | PAL B.G.H/SECAM B.G |
I:PAL I
DK: | PAL D/SECAM D.K.K1 |
M:NTSC (For NV-FJ620BD/BDX)
On Screen Display
AUTO TUNING |
| AUTO TUNING IS |
IN PROGRESS, |
| COMPLETED. |
PLEASE WAIT. |
|
|
|
| RF SELECT ≥ BG I DK M |
CH 22 SEARCH | 21 | RF SELECT: END: MENU |
END: MENU |
| |
During Plug in Auto Tuning | After Plug in Auto Tuning |
3 Press the MENU button U.
To Change the RF output Channel
In some rare cases after tuning the TV to your VCR, interference may be visible on the picture. To get rid of this interference, you can manually adjust the RF output channel a few channels up and down from the current setting. The procedure is described below.
Operations
1Hold down MENU button U for 5 seconds or more.
–The VCR display changes as shown below and the VCR picture on the TV displays this pattern.
VCR display
Panasonic VCR
RF SELECT ≥ BG I DK M
RF SELECT: 
END: MENU
Example
2Enter the desired channel number
–Ensure that the VCR/TV switch E is set to [VCR].
–Set the RF output channel of the VCR to [ss] (RF OFF) when the VCR is connected to the TV via the Audio/ Video cable.
Press the Channel button N to display [ss].
21 
69
ss
(RF OFF)
Example: 28: 2 | 8 |
3Press the MENU button U to finish the setting mode.
4Retune your TV to the new RF channel for the VCR.
Note:
–Even if the RF output channel has been changed, it is not necessary to perform Auto Tuning.
6