Pelco DX8100 Series manual Removing a Drive, Removing Sata Power and Data Cables

Page 10

REMOVING A DRIVE

NOTE: When disconnecting the data and power cables, be sure to pull straight up on the connectors. Do not move the connectors back and forth or remove a connector by pulling it out by its wires.

1.Disconnect the SATA power connector and data cable (refer to Figure 3):

a.Grasp the top of each end of the SATA power connector and carefully and simultaneously pull straight up on the connector.

b.Grasp the top of each end of the SATA data connector and carefully and simultaneously pull straight up on the connector.

2.If a data drive is installed in the system drive basket, disconnect the SATA power and data cable.

Figure 3. Removing SATA Power and Data Cables

10	C2639M-B (8/09)

Image 10

Contents DX8100 Series Hybrid Video Recorders Page Contents List of Illustrations Important Safety Instructions Unit must be shut down to install the system and data diskParts List and Tools DescriptionInstalling a Hard Disk Drive Opening the Chassis Removing Chassis CoverInterior Component Layout DVD-RWRemoving Sata Power and Data Cables Removing a DriveLift the drive out of the basket Installing a Drive Setting Up the System Drive Partitioning the System DriveDX8100 Boot Settings View Press Enter. The Boot Device Priority screen appears Installing Windows and DX8100 Application Software Page Setting UP the System Data Partition Formatting the System Drive Data PartitionClick Format. The Format E dialog appears refer to Figure Optional Configuring the Data Drive Setting Up a Video Data Drive Configuring a Hard DriveSelect Disks to Initialize Dialog Converting a Dynamic Disk to a Basic Disk Data Disk Status Changed to DynamicPartitioning the Data Disk Reinstalling the DX8100 Allocating a Drive Allocating a System and Data Drive SimultaneouslyC2639M-B 8/09 Allocating a NEW Video Data Drive Viewing the Unallocated DriveC2639M-B 8/09 Revision History Product Warranty and Return Information