Using The Remote Control
Using the the remote control is the only way to access menu settings. There are no access controls on the display unit.
The remote control projects a series of IR (infrared) pulses to the PMCD750 display for control. Aim the remote control at a single display and press MENU. The main menu should be visible if the lamp is on. Refer to Figure 11 for remote control buttons and their associated commands/ actions.
SOURCE
CHANGES THE DISPLAYED INPUT
ON
TURNS THE LAMP ON
OFF
TURNS THE LAMP OFF
SAVE
SUCCESSIVELY OPENS THE RECALL
AND SAVE MENUS WITH EACH PRESS
MONITOR
SUCCESSIVELY OPENS THE
MENUS FOR DISPLAY STATUS,
SERIAL PORT STATUS
SERIAL PORT STATUS
AND TEST PATTERNS WITH
EACH PRESS
MENU
OPENS THE MAIN MENU
WALL
OPENS THE ASPECT
RATIO AND WALL MENU
PREV
SELECTS THE PREVIOUS MENU
NAVIGATES UP IN MENUS
AND IMAGE POSITIONING
OPENS THE PREVIOUS MENU, CHANGES
THE VALUE OF A SELECTED ITEM,
AND NAVIGATES LEFT IN MENUS AND
IMAGE POSITIONING
Figure 11. Remote Control Layout
CURTAIN
TURNS THE CURTAIN PATTERN ON AND OFF
LEVEL
OPENS THE INPUT LEVELS MENU
FREQ/PHASE
OPENS THE PICTURE MENU
SETUP
PERFORMS
AUTO SETUP OPTIONS
SIZE/POS
SUCCESSIVELY OPENS THE
PICTURE POSITION, ZOOM
TOP & LEFT, AND ZOOM
BOTTOM & RIGHT MENUS
WITH EACH PRESS
MISC
SUCCESSIVELY OPENS THE
COLOR BALANCE, MISCELLANEOUS, LAMP SETTINGS, SERIAL PORT SETTINGS, AND AUTO SETUP MENUS WITH EACH PRESS
ENTER
SELECTS THE HIGHLIGHTED ITEM AND, IN SOME CASES, CHANGES THE VALUE
OPENS THE NEXT MENU, CHANGES THE VALUE OF A SELECTED ITEM, AND NAVIGATES RIGHT IN MENUS AND IMAGE POSITIONING
NAVIGATES DOWN IN MENUS AND IMAGE POSITIONING
13 |