Sony TC-L47E5 First Time Setup, Turn the TV On with the Power button, Configure your viewing mode

First Time Setup

The first time setup screen is displayed only when the TV is turned on for the first time after the power cord is inserted into a wall outlet and when “Auto power on” (p. 53) is set to “No”.

Turn the TV On with the POWER button

(TV) (Remote)

POWER

or

or

Configure your viewing mode

Getting

POWER

OK

Select your language

Language / Idioma / Langue Step 1 of 7 / Paso 1 de 7 / Étape 1 de 7

Select your language

Seleccione su idioma

Sélection de la langue

English Español Français

Select OK

Selección

Sélection

OK	select
	OK

started ••

Select your country

Country Step 2 of 7

Select the country where this TV is being used.

U.S.A. Canada Other

OK

Select RETURN

OK	select
	OK

First Time Setup Identifying Controls

Select your viewing mode (Be sure to select “Home use”)

Set viewing mode		Step 3 of 7
	Select your viewing environment		select
		OK
	Home use	Store Demonstration
			OK
Select	OK
	RETURN

●Please confirm your selection (Home Use) before pressing OK button.

■If you select “Store Demonstration” by mistake in , confirmation screen will be displayed.

You are selecting the store demonstration mode.

Yes No OK select

If you select “Yes”, the picture mode will regularly reset

to “Vivid” and a Picture Refresh message will be displayed on the OK screen.

●Select “No” and return to previous screen .

●If you select “Yes”, screen enters the store demonstration mode.

To display the “Set viewing mode” screen again as shown above and select “Home use”, do one of the following:

•Press and hold down the rear POWER button for at least five seconds.

•Unplug power cord for 30 seconds and plug in again.

Note
●If you use any other step other than	then turn the TV off, or if you used the EXIT

button to quit before completing the settings, the next time you turn the TV on, “First time setup” will not be automatically displayed.

• The settings up to that point are saved.

• You can start “First time setup”. (p. 53)

●Language, ANT/Cable setup, Input labels, Clock can also be changed from the Settings Menu. (p. 52)

15