SAFETY INSTRUCTIONS
Safety Instructions for the Operator | Safety Instructions for the Installer |
WARNING
Do not open the equipment.
Only qualified personnel should work inside
the equipment.
Do not disassemble or modify the equipment.
Fire, electrical shock or serious injury can result.
Use the proper fuse and power cable.
Fuse rating is shown on the equipment. Use of a wrong fuse can result in damage to the equipment.
Immediately turn off the power at the switchboard if the equipment is emitting smoke or fire.
Continued use of the equipment can cause fire or electrical shock. Contact a FURUNO agent for service.
Do not place any object near the exhaust or intake vent.
Fire may result.
CAUTION
Do not connect/disconnect the signal cable while turning the power on.
The unit may be damaged.
A warning label is attached to the equipment. Do not remove the label. If the label is missing or damaged, contact a FURUNO agent or dealer.
WARNING | Name: Warning Label (1) | |
Type: | ||
To avoid electrical shock, do not | ||
remove cover. No | Code No.: | |
parts inside. |
|
WARNING
Do not open the cover unless totally familiar with electrical circuits and service manual.
Improper handling can result in electrical shock.
Turn off the power at the switchboard before beginning the installation.
Fire or electrical shock can result if the power is left on.
Do not install the equipment where it may get wet from rain or water splash.
Water in the equipment can result in fire, electrical shock or damage to the equip- ment.
CAUTION
Observe the following compass safe distances to prevent interference to a magnetic compass:
| Standard | Steering | |
| compass | compass | |
|
|
| |
LCD Monitor | 1.55 m | 1.0 m | |
|
|
| |
Remote Controller | 0.3 m | 0.3 m | |
|
|
When lifting the display unit, hold it together with the hard cover.
Grasping by the hard cover alone may allow the display unit to fall, resulting in possible bodily injury or damage to the equipment.
i