Lenovo LT3053P manual Manual image setup

Table 3-2.Troubleshooting

	Problem		Possible cause	Suggested action	Reference
The power		The video signal cable		Be sure the video cable is	"Connecting and
indicator is amber,		is loose or disconnected		connected with the system	turning on your
but there is no		from the system or		properly.	monitor"on page 1-7
image.		monitor.
		The monitor brightness		Adjust the brightness and	"Adjusting your
		and contrast are at the		contrast setting on the OSD	monitor image"on page
		lowest setting.		menu.	2-3
One or more of the		This is a characteristic		If there are more than five	Appendix A."Service
pixels appear		of the LCD technology		pixels missing, contact the	and Support"on page
discolored.		and is not an LCD		Support Center.	A-1
		defect.
•	Fuzzy lines in	•	Image setup has not	Adjust the resolution	"Adjusting your
	text or a		been optimized.	settings on your system to	monitor image"on page
	blurry image.	•	Your system	match the native resolution	2-3
•	Horizontal or			for this monitor: 1920 x
			Display Properties
				1080 at 60 Hz.
	vertical lines		setting have not
	through the		been optimized.	Perform automatic image	"Selecting a supported
	image.			setup. If automatic image	display mode"on page
				setup does not help, perform	2-9
				manual image setup.
				When working in the native	See the Advanced
				resolution, you may find	section of your
				additional improvements by	system’s display
				adjusting the Dots Per Inch	properties.
				(DPI) setting on your
				system.

Manual image setup

If automatic image setup does not establish the image that you prefer, perform manual image setup.

Note: Have your monitor powered on for about 15 minutes, until the monitor warms up.

1. Press to open the OSD menu.

2.Use or to select and press to access.

3.Use or to select and press to access.

4.Use or to select Clock or Phase adjustment.

•Clock: (pixel frequency) adjusts the number of pixels scanned by one horizontal sweep. If the frequency is not correct, the screen shows vertical stripes and the picture does not have the correct width.

•Phase: adjusts the phase of the pixel clock signal. With a wrong phase adjustment, the picture has horizontal disturbances in light picture.

5.When the image no longer looks distorted, select Save to save the adjustments of Clock and Phase.

6.Press to leave the OSD menu.

Chapter 3. 3-4