JVC HR-A230EK specifications Number, Timer RECORDINGcont

18TIMERRECORDING(cont.)

ENTER PLUSCODE NUMBER

4 Press OK, and "– –" appears. Then, using the NUMBER keys, input the PlusCode (found in most TV listings) of a program scheduled to be broadcast on each station on the list from step 1, starting at the top. If you enter the wrong number, press CANCEL and input the correct number.

	ENTER PRESET POSITION
5	NUMBER		-
	-
4	Press OK and Preset Position number begins blinking.
		Preset Position	Guide Channel

If the blinking Preset Position number agrees with the Preset position . . .

. . . press OK.

If the numbers do not agree . . .

. . . input the Preset position using PUSH JOG%Þ or the NUMBER keys, then press OK.

●If you input the PlusCode number of a program that has already aired, “Err”(or) appears on the front display for a few seconds. Input the correct PlusCode number.

●Repeat steps 4 and 5 as necessary.

RETURN TO NORMAL

DISPLAY

6 Press CH SET and selection is complete.

If you already know the Guide Channel number for a station . . .

1– After step 3, press PUSH JOG %.

●The Guide Channel number begins blinking.

2– Enter the Guide Channel number using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG %.

●The Preset Position number begins blinking.

3– Enter the preset position using the NUMBER keys or PUSH JOG%Þ, then press OK.

●Repeat 1 and 3 as necessary. 4– Press CH SET.

THE SATELLITE RECEIVER IS SHOWN CONNECTED TO THE “AV2 IN” (SCART) CONNECTOR AND THE CABLE SYSTEM CONNECTED VIA THE AERIAL SOCKET AND TUNED TO, FOR EXAMPLE, PRESET POSITION 5 ON YOUR TV.

Satellite Antenna Cable

Satellite	Cable
Receiver	system

TV Receiver

NOTES:

●If you own a satellite receiver, connect it to the AV2 IN connector on the back of the recorder. Then, in step 5 above, set the input mode to "AU2" by pressing NUMBER key "0" or TV PROG. +/–.

●If you’re receiving broadcasts via a cable box through preset “5” (example) on your recorder, select the preset position 5 in step 5.

●After selecting the programme you wish to record from your cable system or satellite receiver, set the system’s timer — if your cable or satellite receiver does not have a timer, leave it switched on.