JVC HR-J6003UM manual Access Auto SP/EP, Auto SP/EP Timer

28

MENU

q

CH

TIMERRECORDING(cont.)

		Auto SP/EP Timer
		If, when recording in SP mode, there is not enough tape to
		record the entire program, the VCR automatically switches to EP
OK		mode to allow complete recording. This feature is especially
		handy when recording a program of more than 2 hours in
		length.
5/8		For Example . . .
6 ª	£
–	+
		Recording a program of 140 minutes in length onto a 120-
		minute tape

Approximately 110 minutes	Approximately 30 minutes
SP mode	EP mode

Total 140 minutes

1 2

4 5

78

0

OK

3

6

9

MENU

CH

Make sure you select “ON” at the Auto SP/EP Timer screen before performing timer programming.

	ACCESS MAIN MENU
	SCREEN
1 Press MENU.
	ACCESS FUNCTION SET
2	SCREEN
	Place the arrow next to "FUNCTION SET" by pressing
	CH5°, then press OK.
	ACCESS AUTO SP/EP
	TIMER SCREEN
	Place the arrow next to “AUTO SP/EP TIMER” by
3 pressing CH5°, then press OK.
4	SELECT MODE
	Place the arrow next to	AUTO SP/EP TIMER
	your choice (“ON” or
	“OFF”) by press CH5°.	=ON
		OFF
		PRESS (5,°) TO SELECT
		PRESS (MENU) TO END
	RETURN TO NORMAL
	SCREEN

NOTES:

●If you have programmed the VCR to timer-record 2 or more programs, the second program and those thereafter may not fit on the tape if you set the Auto SP/EP Timer mode to "ON". In this case, make sure the mode is not engaged, then set the tape speed manually during timer programming.

●There may be some noise at the point on the tape where the VCR switches from SP to EP mode.

●The Auto SP/EP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes other than the following: T-30, T-60, T-90, and T-120.

5 Press MENU as many times as necessary.