JVC HR-J630U manual Make Connection, Tape Position Indicator, Next-Function Memory

24

PLAYBACKANDRECORDINGFEATURES(cont.)

POWER		REW	FF
		2	2
		q	5/8 6
			PLAY
MENU		OK
		POWER
1	2	3
4	5	6
7	8	9
	0	TIMER

FF

REW

OK

MENU

SHUTTLE PLUS

Tape Position Indicator

The Tape position indicator appears
on screen when, from the stop
mode, you press FF, REW or perform
an Index Search or Instant ReView.			+	+	+
The position of "	" in relation to "B"	B					E
(Beginning) or "E" (End) shows you
where you are on the tape.			COUNT			0:33:27
** SUPERIMPOSE must be set to

ON, or the indicator will not appear (☞ pg. 21).

Next-Function Memory

The Next Function Memory “tells” the VCR what to do after rewinding.

*Before continuing, ensure that the VCR is in stop mode. a– For Automatic Start Of Playback After Tape Rewind . . .

. . . press REW, then press PLAY within 2 seconds. b– For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press POWER within 2 seconds. c– For Automatic Timer Standby After Tape Rewind . . .

. . . press REW, then press TIMER within 2 seconds.

AV COMPU LINK Playback

Your VCR is compatible with JVC’s AV COMPU LINK compo- nents, including amplifiers, receivers, and televisions.

1	MAKE CONNECTION
	Connect your VCR to an AV COMPU LINK component
	as shown in the illustration on page 25.
	• The AV COMPU LINK cable is a mono 3.5 mm mini-
	plug to mono 3.5 mm mini-plug connector.

2	TURN ON THE VCR
	Press POWER.
	ACCESS MAIN MENU
3	SCREEN
	Press MENU.
	ACCESS FUNCTION SET
	SCREEN
	Press CH5° or SHUTTLE PLUS 5° to place the arrow
4 next to “FUNCTION SET”, then press OK.