JVC HR-J780EU, HR-J781EU specifications 42 EN, For Example

Page 42

42 EN

 

SUBSIDIARY SETTINGS (cont.)

 

 

* The default setting is bold in the table below.

 

 

 

 

 

8 AUTO SP]LP TIMER

 

When this function is set to “ON”, the recorder

ON

 

automatically switches to LP mode to allow complete

OFF

 

recording if there is not enough tape to record the entire

 

 

programme while timer-recording in SP mode.

 

 

For Example . . .

 

 

 

 

Recording a programme of 210 minutes in length onto a

 

 

180-minute tape

 

 

 

 

Approximately 150 minutes

Approximately 60 minutes

 

 

SP mode

LP mode

 

 

 

 

 

 

 

 

Total 210

minutes

 

 

 

Make sure you set this function to “ON”, before the timer-

 

 

recording starts.

 

 

 

 

NOTES:

 

 

 

 

● If you have programmed the recorder to timer-record 2 or more

 

 

programmes, the second programme and those thereafter may

 

 

not fit on the tape if you set “AUTO SP]LP TIMER” to “ON”. In

 

 

this case, make sure the mode is not engaged, then set the tape

 

 

speed manually during timer programming.

 

 

● In order to ensure that the recording fits on the tape, this feature

 

 

may leave a slight non-recorded section at the end of the tape.

 

 

● There may be some noise and sound disturbance at the point on

 

 

the tape where the recorder switches from SP to LP mode.

 

 

● The Auto SP]LP Timer feature is not available during ITR

 

 

(Instant Timer Recording), and the feature will not work

 

 

properly with any tapes longer than E-180, or with some tapes

 

 

of shorter lengths.

 

 

 

 

● If you perform timer recording with both VPS/PDC and the Auto

 

 

SP]LP Timer activated, and the programme goes beyond its

 

 

originally scheduled length, there may be times when the

 

 

programme cannot be recorded in its entirety.

 

 

 

 

 

8 POWER SAVE

 

When this function is set to “ON”, you can reduce the

ON

 

power consumption while the recorder is turned off.

OFF

 

NOTES:

 

 

 

 

 

 

 

 

● During Power Save mode ...

 

 

 

 

... the front display panel will be turned off.

 

 

... the Just Clock function ( pg. 44) does not work.

 

 

... the picture may be distorted momentarily when you turn on/

 

 

off the recorder.

 

 

 

 

● Power Save does not work when ...

 

 

... the recorder is in the Timer mode.

 

 

... the recorder’s power is turned off after timer-recording or

 

 

Instant Timer Recording.

 

 

 

 

... the Auto Satellite Programme Recording mode is engaged

 

 

( pg. 31).

 

 

 

 

... “L-2 SELECT” is set to “DECODER” or “SAT” ( pg. 43).

 

 

 

 

 

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Video Cassette Recorder English Safety Precautions Moisture Condensation Front View Front Display Panel ON-SCREEN Display How To Use Operating JVC TVsConnect the recorder to TV Check the contentsSituate the recorder Connect the recorder to mainsSelect your country Auto Set UpTurn on the recorder Before starting, make sure of the followingOn the front display panel Perform Auto Set UpSelect the language On the on-screen displaySet the video channel Perform Preset Download10 EN Press rt to select CH - and press OK or eLanguage for the on-screen display Just ClockLanguage Access the Main Menu screenAccess the Country Set screen 12 ENAttach the Satellite Controller Installing Satellite ControllerSituate the Satellite Controller Make connectionsSetting satellite receivers brand and channel 14 ENTV Auto Power On NexTView LinkVCR Auto Standby Direct Rec Basic Playback 16 ENActivate Frame-by-frame playback High-Speed SearchPause during playback Push the JOG dial PressManual Tracking 18 ENVariable Speed Search Including Slow Motion Instant ReViewNext Function Memory Index SearchSkip Search Repeat Playback20 EN Watching Another Instant Timer Recording ITREngage the ITR mode Set the recording durationTape Remaining Time Reset the counter22 EN Receiving Stereo And Bilingual ProgrammesPlayback RecordingBefore performing the Showview Timer Programming Access the Showview screenAccess the Showview Program screen 24 ENSatellite Receiver Users Set the VPS/PDC modeEngage the recorder’s timer mode Guide Program Number SetExpress Timer Programming 26 ENEnter the channel position To Timer-Record Weekly Or Daily SerialsVPS/PDC Recording Press PR +28 EN Enter the programme modeBefore performing the 24 Hour Express Timer Programming Set the programme start/stop time and channelReturn to the timer mode Check, cancel and change programmesCancel or change a programme Disengage the timer modeSelect the programme to modify Cancel or change programme settingConfirm the overlapping programmes Overlapping programmes blink on the TV screenProgramme Recording Select the L-2 Select modeEngage the Auto Satellite Programme Recording mode Before performing the following stepsEdit From a Camcorder 32 ENStart the source player Set the input mode of recording deckAnother Video Recorder Start the recording deckAudio Dubbing 34 ENStart dubbing Engage the Audio Dubbing modeLocate the start point End Audio DubbingConnecting To a Satellite Receiver Set the tuner Select the input modeConnect the decoder Set L-2 Select to DECODER.  pg38 EN Make connectionsGuide Program Number Showview System SetupGuide Program Number Set Enter the Guide Program numberSelect the mode Mode SetAccess the Mode Set screen Select the mode settingWhen this function is set to ON, the timer is You can set the B.E.S.T. Biconditional Equalised SignalThis feature helps you to adjust the playback picture Off, and automatically disengaged when the recorder is42 EN For ExampleAbout Ntsc Playback Access the Clock Set screen Clock Set44 EN Set the source channel position for clock data Set the date and timeSet Just Clock Start the clock operation46 EN Access the Auto Channel Set screenTuner Set Auto Channel SetPerform Auto Channel Set View the Confirmation screenPress OK twice 48 EN Manual Channel SetWhen Receiving a Scrambled Broadcast Delete a Channel50 EN Set Stations aSet Stations B TV Station And ID List Station NameVideo Channel Set Access the Video Channel Set modeExit the Video Channel Set mode 52 ENPower 54 EN RecordingOther Problems 56 EN PlaybackMemory backup time Approx min Signal-to-noise ratio 45 dBHorizontal resolution Scan system58 EN Memo

HR-J781EU, HR-J780EU specifications

The JVC HR-J780EU and HR-J781EU are two impressive VCR models that showcase JVC's commitment to providing high-quality video recording and playback. Released during the height of VHS technology, these models stand out due to their robust features, advanced technologies, and user-friendly characteristics, making them a popular choice among enthusiasts and casual users alike.

One of the standout features of both models is the incorporation of JVC’s innovative Digital Scene Selector technology. This allows for enhanced image processing, resulting in sharper and clearer video quality. The Digital Scene Selector analyzes incoming video signals and optimizes them in real-time, ensuring that every frame is rendered to its fullest potential.

Both the HR-J780EU and HR-J781EU come equipped with a Time Base Corrector (TBC), which significantly improves the stability of the video image. This technology reduces jitter and enhances overall playback quality, making these VCRs excellent for archiving and preserving precious home videos. The TBC is particularly beneficial when playing back older tapes that may have degraded over time.

Another key characteristic of the JVC HR-J780EU and HR-J781EU is their ability to support long-play (LP) recording modes. This feature enables users to store more content on a single tape, doubling the recording capacity without a noticeable dip in quality. For regular viewers and home movie creators, this is an excellent advantage, allowing for longer viewing and recording sessions without the hassle of frequently changing tapes.

Both models are equipped with a comprehensive set of connectivity options, including SCART and composite outputs, making it easy to connect to various TVs and other playback devices. Additionally, the inclusion of an easy-to-navigate on-screen menu enhances user experience, allowing users to quickly access settings and functionalities.

Moreover, the JVC HR-J780EU and HR-J781EU boast built-in auto tracking features, which automatically adjust the tape heads to maintain optimal playback quality. The sleek design, combined with a remote control for convenience, makes these VCRs both aesthetically pleasing and practical.

In summary, the JVC HR-J780EU and HR-J781EU are finely crafted VCR models that showcase advanced recording technologies, user-friendly features, and excellent performance characteristics. For those looking to relive nostalgic moments captured on VHS tapes, these models provide a reliable and high-quality option for both recording and playback.
Top Page Image Contents