JVC HR-J633U manual Select D.S.T. Mode, Select Mode, SET DATE, Time and D.S.T, Make Corrections

MANUAL CLOCK SET

DATE 1/ 1/96 MON

TIME – – : – – AM

D.S.T.ON

PRESS NUMBER KEY(0-9)

OR (5,°), THEN (OK)

PRESS (MENU) TO END

D.S.T. SELECT

=AUTO

ON

OFF

PRESS (5,°) TO SELECT

PRESS (MENU) TO END

10

INITIALSETTINGS(cont.)

OK

2

q 5/8

MENU

	1	2	3
NUMBER	4	5	6
	7	8	9
		0

CH

2

6

SELECT D.S.T. MODE

6 You have three choices: a–Select “AUTO” and the adjustment to your VCR’s clock will be made according to the incoming signal from the host channel.

b–Select “ON” and the adjustment will be made based on the clock itself.

c–Select “OFF” if Daylight Saving Time doesn’t apply to you.

Place the arrow next to your choice by pressing

CH5° or SHUTTLE PLUS 5°, then press MENU and the Semi-Auto Clock Set screen reappears.

IMPORTANT

After performing the Semi-Auto clock set procedure, make sure that the VCR is off before the next hour so that the clock can be set. (The clock is automatically adjusted on the hour except at 11:00 PM, midnight, 1:00 AM and 2:00 AM.)

Manual

OK

MENU

SHUTTLE PLUS

2

3

4

SELECT MODE

At the Override Auto Clock Set screen, place the arrow next to “MANUAL CLOCK SET” by pressing CH▲▼ or SHUTTLE PLUS 5°, then press OK.

SET DATE, TIME AND D.S.T.

The Manual Clock Set screen is displayed and the first setting that can be set begins flashing.

Press the appropriate NUMBER keys to set the date and time (if only 1 digit, press "0" first). Press CH▲▼ or SHUTTLE PLUS

5° to set AM/PM and D.S.T. (Daylight Saving Time) to “ON” (automatic adjustment based on VCR’s clock) or “OFF” (if D.S.T. doesn’t apply to you).

Press OK after AM/PM and D.S.T. settings. The next setting that can be set begins flashing. When you’re finished with this set-up procedure, press MENU to start the clock.

NOTE:

CH5° and SHUTTLE PLUS 5° can be used to perform all operations. (In this case, press OK after each setting.)

MAKE CORRECTIONS

To change any of the settings, press OK or SHUTTLE PLUS ª £ until the item you want to change blinks, then set as in step 3.