JVC LPT0592-001C, HR-J387EM, HR-J381EM manual Timer Recording, Express Timer Programing

Timer Recording

Up to 8 timer recording programs can be made using Express timer programing method as far as a year in advance. Remember, the clock must be set before you can program the timer.

NOTES:

●If all the 8 programs have already been set, “PROGRAM FULL” appears on the TV screen.

●After timer recording is completed, the recorder turns off automatically.

●You can program the timer recording while a regular recording is in progress; the menu screens will not be recorded.

●In case of a power failure after programming, the recorder’s memory backup keeps your selections (if the lithium battery is not exhausted).

Express Timer Programing

●Remember, the clock must be set before you can program the timer.

●Load a cassette with the record safety tab intact. The recorder turns on, and the counter is reset, automatically.

●Select the appropriate colour system with “PAL/MESECAM” and “NTSC” in Function settings.

APress PROG on the remote control to access the Program screen.

B Press START+/–,STOP+/–,DATE+/–		– P1 –
or PR+/– repeatedly to enter the start	START	STOP
	21:00	–:– –
time, stop time, date or channel.
		SP
● Press and hold START+/– or
	DATE	TV PROG
STOP+/– to increase the time in
	– –.– –	– –
30-minute intervals.	[+/–]
● To set the tape speed, press SP/LP/	[PROG] : EXIT
EP (p).

● To timer-record daily (Monday–Friday) or weekly serials, press DAILY or WEEKLY. Pressing the button again makes the “DAILY” or “WEEKLY” display disappear.

CPress OK or PROG.

●If “PROGRAM OVERLAPPED” appears, see “Program overlap warning display”.

DPress #. The recorder turns off automatically and “#” is displayed on the display panel.

NOTE:

●If the tape reaches its end during timer recordings, the recording stops and “#”, “” and “ $” on the front display panel blink.

To use the recorder while it is in timer recording standby mode

Press #, then press 1. After you use the recorder, press # again to put the recorder into timer recording standby mode.

Checking, canceling or changing program settings

ADisengage timer

Press #, then press 1.

●When “AUTO TIMER” is set to “ON”, you do not have to press

#.

B Access Program Check screen						PR START		STOP	CH	DATE
Press	"	.			1		8:00	10:00	3	24.04
					2		10:00	10:45	2	25.04
● When the weekly serials are programed,					3		11:30	13:00	1	25.04
					4
a day of the week appears, when the					5
					6
daily serials are programed, “DAILY”					7
					8
appears.
					[		] : NEXT
C Access Program screen							START	– P1 –	STOP
Press	"	again. Each time you press	"	,
							8:00		10:00
the next program’s Program screen									SP
appears.							DATE		TV PROG
							24:04		3
					[	] : NEXT

DCancel or change program setting

To cancel a program, press & when the Program screen you do not want is shown.

To change a program, press the appropriate button: START+/–, STOP+/–, DATE+/–, PR+/–, and/or SP/LP/EP (p) when the Program screen on which you want to make changes is shown.

EReturn to normal screen

Press " repeatedly until no Program screen is shown.

FReengage timer recording standby mode

Press #. The recorder turns off automatically and “#” is displayed on the display panel.

●When “AUTO TIMER” is set to “ON”, the timer recording standby mode automatically resumes when you turn off the recorder.