Go-Video DVD 22 owner manual Safety Information

Page 4

SAFETY INFORMATION

Verify Line Voltage Before Use

Your DVD 22 has been designed for use with

110 –230-volt AC current and the plug is specifically designed for 120-volt applications. Connection to

a line voltage other than that for which it is intended can create a safety and fire hazard and may damage the unit.

If you have any questions about the voltage require- ments for your specific model, or about the line volt- age in your area, contact your selling dealer before plugging the unit into a wall outlet.

Do Not Use Extension Cords

We do not recommend that extension cords be used with this product. As with all electrical devices, do not run power cords under rugs or carpets or place heavy objects on them. Damaged power cords should be replaced immediately by an authorized service center with cords meeting factory specifications.

Handle the AC Power Cord Gently

When disconnecting the power cord from an AC out- let, always pull the plug; never pull the cord. If you do not intend to use the unit for any considerable length of time, disconnect the plug from the AC outlet.

Do Not Open the Cabinet

There are no user-serviceable components inside this product. Opening the cabinet may present a shock hazard, and any modification to the product will void your guarantee. If water or any metal object such as a paper clip, wire or staple accidentally falls inside the unit, disconnect it from the AC power source immedi- ately, and consult an authorized service center.

Installation Location

To ensure proper operation, and to avoid the potential for safety hazards, place the unit on a firm and level surface. When placing the unit on a shelf, be certain that the shelf and any mounting hard- ware can support the weight of the product.

Make certain that proper space is provided both above and below the unit for ventilation. If this product will be installed in a cabinet or other enclosed area, make certain that there is sufficient air movement within the cabinet.

Do not place the unit directly on a carpeted surface.

Avoid moist or humid locations.

Avoid installation in extremely hot or cold locations, or an area that is exposed to direct sunlight or heating equipment.

Do not obstruct the ventilation slots on the top of the unit, or place objects directly over them.

Cleaning

When the unit gets dirty, wipe it with a clean, soft, dry cloth. If necessary, wipe it with a soft cloth dampened with mild soapy water, then a fresh cloth with clean water. Wipe immediately with a dry cloth. NEVER use benzene, aerosol cleaners, thinner, alcohol or any volatile cleaning agent. Do not use abrasive cleaners, as they may damage the finish of metal parts. Avoid spraying insecticide near the unit.

Unpacking

The carton and shipping materials used to protect your new receiver during shipment were specially designed to cushion it from shock and vibration. We suggest that you save the carton and packing materials for use in shipping if you move, or should the unit ever need repair.

To minimize the size of the carton in storage, you may wish to flatten it. This is done by carefully slitting the tape seams on the bottom, and collapsing the carton down to a more two-dimensional appearance. Other cardboard inserts may be stored in the same manner. Packing materials that cannot be collapsed should be saved along with the carton in a plastic bag.

If you do not wish to save the packaging materials, please note that the carton and other sections of the shipping protection are recyclable. Please respect the environment and discard those materials at a local recycling center.

Remove Front-Panel Protective Film

In order to protect the lens covering the front panel of your new DVD 22, it is shipped from the factory cov- ered by a protective plastic film. Before using the unit, remove this film by grabbing one corner and gently peeling back the plastic sheet. Note that the film must be removed for proper operation of the remote control.

Moving the Unit

Before moving the unit, be certain to disconnect any interconnection cords with other components, and make certain that you disconnect the unit from the AC outlet.

IMPORTANT NOTE: To avoid damage to the DVD 22 that may not be covered by the warranty, be certain that the disc is removed from the unit before it is moved. Once the DVD 22 is installed, a disc may be left in the unit when it is turned off, but the unit should NEVER be moved with a disc left in the disc tray.

Important Information for the User

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment gener- ates, uses and can radiate radio-frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that harmful interference will not occur in a particular instal- lation. If this equipment does cause harmful interfer- ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause undesired operation.

NOTE: Changes or modifications may cause this unit to fail to comply with Part 15 of the FCC Rules and may void the user’s authority to operate the equipment.

CAUTION: The DVD 22 uses a laser system. To pre- vent direct exposure to the laser beam, do not open the cabinet enclosure or defeat any of the safety mechanisms provided for your protection. DO NOT STARE INTO THE LASER BEAM. To ensure proper use of this product, please read this Owner’s Manual care- fully and retain it for future use. Should the unit require maintenance or repair, please contact your local Harman Kardon service center. Refer servicing to qualified personnel only.

4 SAFETY INFORMATION

Image 4
Contents DVD DVD Video PlayerTable of Contents DVD 22 DVD PlayerIntroduction Risk of Electric Shock Do not OpenSafety Information Features & DVD Compatibility DVD 22 can play the following types of pre- recorded discs8cm disc 12cm discDVD Terminology FRONT-PANEL Controls Chapter/Track Number Indicators N Time Indicators VCD Playback Control IndicatorFRONT-PANEL Information Display Random Repeat IR Emitter Remote Control FunctionsB Repeat I Angle J Zoom Light Press to illuminate remote controller Off Turns off the player to standby modeNumeric Keys Press these buttons to enter a number ¶ Remote Control Output Remote Control Input ª AC Power CordREAR-PANEL Connections ¢ S-Video OutputSetup and Connections Connecting to a TV and Analog ReceiverTo video input Connector yellow Video input jack onlyDolby Digital/DTS Receiver or Processor Audio ConnectionsTo S-Video Input connector Video Display ConnectionsRemote Control Operation Battery InstallationRemote Control Operation Range Service Life of BatteriesFor Your Reference Digital Audio ConnectionsDolby Digital and DTS On the Setup Main Menu the Available Submenus Are System SetupOn the Player Main Menu the Available Submenus Are Setup Menu Audio Setup MenuSystem Setup Menu Subtitle Button , as described onFollowing adjustments are available on the Audio Setup menu Video Setup MenuFollowing adjustments are available on the Video Setup menu Video Adjustments Menu AgainContrast Adjustment Color AdjustmentProper color intensity setting on your TV Test ScreenPlayback Features for DVD and CD Discs Playback Basics for ALL FormatsLoading Discs DVDUsing a DVD’s Menu Zoom FeaturePlayback Resume Feature DVD PlaybackSelecting a Title for DVDs Selecting a Chapter for DVDsSelecting a Track for CDs For DVDsSelecting an Angle DVDs only Repeat PlayButton to remove the display from your screen Selecting or Changing the Subtitle DVDs OnlyMP3, Windows Media and Jpeg Playback MP3, Windows Media and Jpeg PlaybackSpecific File Types That May be Played on the DVD 22 Are One by oneVCD Playback VCD PlaybackOn the remote Playback ControlUsing the Player Menu When all programming is complete, pressUsing the Player Menu for Programmed Playback ‹ › Navigation Buttons 4 until the Title or3h to begin playback in the order you have just programmed DVD Language Codes Troubleshooting Guide DVD 22 Technical Specifications