JVC HR-J231SA specifications SET Counter Memory, Activate Counter

Index Search

Your recorder automatically marks

index codes at the beginning of£ 2 each recording. This function gives

you quick access to any one of 9 index codes in either direction.

NOTE:

Before starting, make sure the recorder is in the Stop mode.

ACTIVATE INDEX SEARCH

1 Press PUSH JOG ª or £. “ª 1” or “£ 1” is displayed on screen and search begins in the corre- sponding direction.

●To access index codes 2 through 9, press PUSH JOG

ªor £ repeatedly until the correct index number is displayed.

Ex.: To locate the beginning of B from the current position, press PUSH JOG ª twice.

To locate the beginning of D from the current position, press PUSH JOG £ once.

Current position

A	B		C	D		E		F
–2		–1	1		2		3
		ª £
						Index			number

●When the specified index code is located, playback begins automatically.

Counter Memory

Returns to the counter reading of “0:00:00” to conveniently find a specific place on the tape automatically.

1	SET COUNTER MEMORY
	Press C. RESET during playback at a point you wish to
	locate later. The counter reads “0:00:00”. Then press C.
	MEMORY, and “M” appears on the front display panel.

	ACTIVATE COUNTER
2	MEMORY
	When you wish to return to the designated point, press
	STOP and then REW or FF.
	● The tape rewinds or fast-forwards and stops at about
	0:00:00 automatically.
	● To cancel Counter Memory, press C.MEMORY again.

13

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can play back NTSC tapes.

1	LOAD A CASSETTE
	Insert a cassette recorded in NTSC.
2	START PLAYBACK
	Press PLAY.
	● Some TVs shrink the picture vertically and place
	black bars at the top and bottom of the screen. This is
	not a malfunction on the part of either the video
	recorder or the TV.
	● The picture may roll up and down. This can be
	corrected using the V-HOLD control found on some
	TVs. (This cannot be corrected if the TV does not
	have a V-HOLD control.)
	● The counter and elapsed tape time readings will be
	incorrect.
	● During search, still, or frame-by-frame playback, the
	picture will be distorted, and there may be a loss of
	colour.
	● Depending on the type of TV, the top and bottom
	portions of superimposed displays may be cut off
	during NTSC playback.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press OPERATE within 2 seconds.

NOTE:

If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C.MEMORY so that the “M” mark appears before pressing REW.