Magnavox VRA651AT Automatic Channel Setup, Press the VCR button, then press the Menu button

Automatic Channel Setup 11

Although your VCR may automatically memorize the channels you receive when you turn it on for the first time, this function lets you set up channels again. Make each entry within one minute of the previous entry.

1

Press the VCR button, then press the MENU button.

5 Wait for the VCR to set up channels.

1

SELECT , 9 CHOOSE >/OK

→VCR SET UP TUNER SET UP INITIAL SET UP

CBL / DBS TV VCR

VCR/TV POWER EJECT

QUICK PROGRAMMING

TO END PUSH EXIT

2

Press the PLAY 8 or STOP 9 button to select TUNER SET UP, then press the FF :/OK button.

SELECT , 9	CHOOSE >/OK
→ CABLE/ANTENNA		CABLE

AUTO CH. PROGRAMMING

ADD/DELETE CH.

TO END PUSH EXIT

3

2-4

1

1	+	2	+		3
START	.............	STOP	.............	DATE
4	-	5	-		6
DBS		DAILY		WEEKLY
7		8			9
SPEED		0		CLEAR
	STILL/SLOW
-					+
........ ........
REW					FF
		PLAY

/OK

STOP

VOL MENU CH

EXIT/STATUS

TIMER

Press the FF :/OK button repeatedly so that ANT (if you have an antenna) or CABLE (if you have a cable connec- tion) appears beside CABLE/ANTENNA.

4

Press the STOP 9 button to select AUTO CH. PRO- GRAMMING, then press the FF :/OK button. AUTO CH. SET PROCEEDING PLEASE WAIT and a scale that shows the progress of channel setup will appear on the screen. The VCR will memorize all the channels you receive.

5

Wait for a few minutes while the VCR sets up channels.

When programming is complete, AUTO CH. SET COMPLETED will appear on the screen. Then, the programming of the lowest channel number placed in the VCR’s memory will appear on the screen. Now when you press the CH(annel) 8/9 button, you will scan only through channels you receive.

SKIP SEARCH	INDEX	AUDIO/MUTE
SMARTPICTURE		REC /OTR

Helpful Hint

•The two Line Input modes will always be stored in the VCR’s mem- ory at channel 00. To select A/V IN FRONT or A/V IN REAR, press 0,0, then press the CH(annel) 8/9 but- ton so that A/V IN FRONT or A/V IN REAR appears on the screen briefly. To exit Line Input mode, use the CH(annel) 8/9 button to select a channel other than 00.