GoVideo DDV 9300 manual Copy Features, Copying a Tape, EZ-Copy

COPYTAPE

COPYTAPE

C H A P T E R 4

Copy Features

Copying a Tape

The Copy Tape button

is your key to one-

touch copies.

Copying tapes is what owning a Dual-Deck VCR is all about. Just follow these simple steps:

1 Insert your source tape into Deck 1 on the left side of the Dual-Deck VCR.

2 Insert your target tape into Deck 2 on the right side of your VCR.

3 Press COPYTAPE on the front panel of your Dual-Deck VCR

or on your remote control. Your Dual-Deck VCR will begin copying from Deck 1 to Deck 2.

Note: When you press Copy Tape, Deck 1 rewinds a few seconds (called “pre-roll”) and Deck 2 goes into Record Pause mode automatically before copying begins. This “synchro-start” results in the best possible quality when copying and editing.

4 To pause the copying process, press . To resume,

press again. To stop the copying process, press STOP on Deck 2.

Turn EZ-Copy on or off in the

Copy Tape Settings menu

EZ-Copy

EZ-Copy automates every step of the Copy Tape process: At the touch of a button, your Dual-Deck VCR automatically rewinds both tapes, copies the entire tape from Deck 1 to Deck 2, rewinds both decks again and ejects the tapes. To activate EZ-Copy.

1 Press MENU until the DUAL-DECK FEATURES menu

appears.

2 Press “2” to select COPY TAPE SETTINGS.

3 Press “3” repeatedly to set EZ-COPY to:

On - EZ-Copy is enabled. To activate, simply insert

your tapes and			If EZ-Copy ends without rewinding
press the
		button.
	COPYTAPE
			and ejecting the tape then a problem
Off - EZ-Copy is
			occurred during the copy. Most likely
	disabled.		the tape in Deck 2 was not long enough
			to record the entire source tape.

CHAPTER 4 - COPY FEATURES 19