Preparation for USE, ANTENNA/CABLE Connections

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

For some of the most common types of connections, please refer to the diagram below. Use only one connection. For any further complex connections, please contact your local dealer. (You may need additional accessories which are not supplied).

1Disconnect the antenna or cable from your TV.

3Connect one end of the coaxial cable (supplied) to the ANT.OUT (Bottom jack) of your VCR.

Basic Connections

2Connect the antenna or cable to the ANT.IN (Top jack) of your VCR.

4Connect the other end of the coaxial cable (supplied) to the UHF/VHF antenna jack of your TV.

	AUDIO		ANT
		L	IN
		L
	OUT	IN
		R
Audio/Video cables	VIDEO		OUT
Audio/Video cables			OUT
(not supplied)	OUT	IN CH3 CH4

Back of the VCR

ININ

L R

AUDIO

VIDEO

Coaxial Cable

(Supplied)

[Cable Box or Satellite Box]

From

Cable or

Satellite

ORCompany

Indoor or Outdoor Antenna

From

Cable Company

(No Cable Box)

VHF	VHF
OR
UHF	UHF

ANT in

STEREO

TV A/V Terminal

TV Antenna Terminal

USING OPTIONAL AUDIO/VIDEO	USING AUDIO/VIDEO INPUT JACKS
OUTPUT JACKS	You can use the A/V input jacks on the front or the back
If your TV has A/V input jacks, you may connect your	of the VCR.
VCR’s AUDIO/VIDEO OUTPUT jacks to the	1) When you connect the external source to input jacks
audio/video input jacks on back of your TV.	on the back of the VCR, select "L1" position for re-
Direct audio/video connections usually result in a better	cording by pressing the 0, 0, 1 on the remote control
picture and sound quality for tape playback. Please see	or CHANNEL Up/Down button.
your TV’s owner’s manual for A/V input connections.	2) When you connect the external source to input jacks
	on the front of the VCR, select "L2" position for re-
	cording by pressing the 0, 0, 2 on the remote control
	or CHANNEL Up/Down button.
	Note: "L1" or "L2" is found before the lowest memo-
	rized channel. (Example: CH2)

Note to CATV system installer

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

- 6 -

0J01