• SW OUTPUT Terminal
While recording, a pulse signal(DC 5V) is output at the SW OUT terminal after each recording period. This terminal is usually connected to the switch input of devices like a camera switching unit, or a quad compressor.
1) Low
2) High
• SERIES OUTPUT Terminal
During recording, when the end of the tape is reached, the output becomes DC 5V .
• SERIES INPUT Terminal
If the input becomes DC 5V for 200 msec or more, the VCR starts series recording.
• WARNING OUTPUT Terminal
1)“High”
If the error display on the display panel continues to flash, the output becomes DC 5V. If the POWER button is pressed, the emergency mode is released, then the output becomes 0V.
2)“Low”
If the error display on the display panel continues to flash, the output becomes 0V. If the POWER button is pressed, the emergency mode is released, then the output becomes DC 5V.
If you are also using a Multi View system, use the following diagrams as a guide to connecting the VCR for normal or alarm recording.
Connecting to a Multiview System for Normal Recording
38 | Time Lapse Video Cassette Recorder | Time Lapse Video Cassette Recorder | 39 |