Battery Installation

REMOTE CONTROL OPERATION

Before attempting to operate your Remote Control, install the batteries as described below.

1)Turn the Remote Control face down. Press down on the ridged area of the battery cover and slide it off.

2)Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is observed.

3)Slide the cover back until it clicks.

The remote control will operate the VOH560PKG, It is not a universal remote control and will not control equipment from other manufacturers.

POWER	VIDEO	REPLAY
	or GAME
PICTURE	–	+
PICTURE
SELECT
	WIRED HEADPHONE
	VOLUME CONTROL
REW		FWD
PLAY		STOP

Remote Controlled Monitor Functions

1. POWER ON/OFF

Press this button to turn the VOH560 On. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. Press the button again to turn the VOH560 Off.

2.VOLUME UP/DOWN BUTTONS

Use these buttons to raise or lower the volume level of the headphone jacks or external speaker if installed. They are also used to make picture adjustments in picture select mode.

Note: These buttons will not affect the volume of wireless headphones or a wired RF modulator. When using these devices the volume must be adjusted with the headphone volume control or with your radio’s volume control (see page 13, Headphones, or page 14, Wired FM Modulator).

3.PICTURE SELECT BUTTON

Each time this button is pressed, the on screen picture adjustment display cycles through “adjustment bars” for CONTRAST, BRIGHTNESS, COLOR and TINT. Once the desired adjustment bar is displayed, use the VOLUME UP/DOWN buttons to adjust the setting. The display will automatically turn off if no adjustments are made within 6 seconds, or if any other button is depressed.

4.SOURCE SELECT BUTTON

Any video equipment connected to the AUDIO / VIDEO inputs can be used with the monitor by pressing this button. Each time the button is pressed, the Audio / Video source will change in the following sequence VIDEO 1 and VIDEO 2.

-11-