Warnings
✦Do not use any solvents or cleaning materials when cleaning the video system.
✦Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened lint free cloth to wipe the screen if it is dirty.
✦Lock the LCD screen in the fully closed position when not in use.
✦Before putting on headphones always adjust the volume setting to the lowest position.
✦Remember to leave the dome light switch in the off or auto positions when the vehicle is unattended, as the dome lights, if left on, can drain the vehicle’s battery.
✦Do not put pressure on the screen.
✦Caution children to avoid touching or scratching the screen, as it may become dirty or damaged.
Troubleshooting
PROBLEM |
|
| SOLUTION |
|
|
| |
Poor radio reception (FM |
| • Check the condition of the vehicle’s radio antenna. | |
modulator installed) |
| • Verify that the antenna is fully raised. | |
|
| • If a wired RF modulator has been installed, verify that its | |
|
| switch is turned to the off position. | |
|
|
| |
IR sensor inoperative |
| • Verify that the batteries in the remote are fresh. | |
|
| • Verify that the remote sensor eye is not obstructed. | |
|
| • Verify that the infrared transmitter is affixed over the sensor | |
|
| eye of the component to be controlled. | |
|
|
|
|
|
| Technical | Specifications |
LCD Backlighting | Edge Light Tube | ||
| Resolution | 960 x 234 | |
|
| Pixels | 224,640 |
Power Supply | 12 Volts + or - 10% | ||
Operation Temperature | 0 – 40°C | ||
Storage Temperature | |||
Expected Backlight Life | 10,000 Hours | ||
Video Display System | NTSC | ||
| Audio Output | 0.6W @ 16 Ω | |