King Controls KD-3200, KD-2200 manual External Wiring, Do not Over Tighten Connections

EXTERNAL WIRING

9.Plug external wire harness into wiring port on back of dome unit and tighten connection until it clicks past the detent lock (Fig. 8).

Note: The King-DomeAIRis wired for multiple receiver support. There are two coax ports on the back of the dome unit.

The one labeled “MAIN” MUST be connected thru the diplexer to the main receiver in vehicle. This is the receiver that will control automatic satellite switching if applicable. The one labeled “AUX” can be used for an additional receiver.

IMPORTANT! You must fill the ends of all external coax cables with the supplied dielectric grease. Failure to do so will void product warranty.

10.Fill end of coax cable that will connect to the MAIN port on the dome unit with supplied dielectric grease. Connect this end of the coax cable to the MAIN port and tighten connection (Fig. 8).

If using a second (auxiliary) receiver, fill end of second coax cable (not supplied) and connect it to the AUX port. Tighten connection.

DO NOT OVER TIGHTEN CONNECTIONS.

Fig. 8

IMPORTANT!

The alignment tabs on the wiring port and the external wire harness plug must match up when engaging plug onto port.

YOU MUST TIGHTEN THE EXTERNAL WIRE HARNESS PLUG UNTIL IT CLICKS PAST THE

DETENT LOCK.

(A channel lock pliers may

be used to tighten the

connection.)

IMPORTANT!

Fill ends of coax cables with supplied dielectric grease.

Failure to do so will void product warranty.

Coax connections should be snug. DO NOT OVER TIGHTEN!

Page 8