LG Electronics RH7850H owner manual Troubleshooting, Symptom Cause Solution

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Solution
No power.	The power cord is disconnected.	Plug the power cord into the wall
		outlet securely.
No picture.	TV/DVD mode for the recorder is set	Press TV/DVD on the remote control
	to TV.	repeatedly to choose DVD mode. TV
		indicator disappears in the display
		window.
	The TV is not set to receive recorder	Select the appropriate video input mode
	signal output.	on the TV so the picture from the
		recorder appears on the TV screen.
	The video cable is not connected	Connect the video cable securely.
	securely.
	The connected TV power is turned off.	Turn on the TV.
No sound.	The equipment connected with the	Select the correct input mode on the
	audio cable is not set to receive	audio receiver so you can listen to the
	recorder signal output.	sound from the recorder.
	The audio cables are not connected	Connect the audio cable securely.
	securely.
	The power of the equipment connected	Turn on the equipment connected
	with the audio cable is turned off.	with the audio cable.
	The audio connecting cord is damaged.	Replace it with new one.
The playback picture is	The disc is dirty.	Clean the disc.
poor.
The recorder does not	No disc is inserted.	Insert a disc. (Check that the disc
start playback.		indicator in the display window is lit.)
	An unplayable disc is inserted.	Insert a playable disc. (Check the disc
		type, color system, and regional code.)
	The disc is placed upside down.	Place the disc with the playback side
		down.
	The disc is not placed within the	Place the disc on the disc tray
	guide.	correctly inside the guide.
	The disc is dirty.	Clean the disc.
	The Rating level is set.	Cancel the Rating function or change
		the rating level.
The picture from the	The video signal from the external	You cannot connect via this recorder.
external input is	component is copy-protected.	Connect the component directly to
distorted		your TV.
Some channels are	Those channels are not stored in the	Restore channels. See “Program Edit”
skipped over when	recorder.	on page 18.
using v / V.
The picture or sound of	Aerial or cables are loose.	Tighten connections or replace cable.
broadcasting channel is		AV2, DV, etc.)	Reference
A/V input or DV IN to
weak or missing.
Camcorder image is not	Camcorder is off.	Turn camcorder on and operate
shown.		properly.
Camcorder image via	The recorder’s source is incorrect.	Use AV to select input channel (AV1,
recorder is not shown
on TV screen.

59