Logitech 895 user manual Using the Infrared Sensor, Naming an Infrared Command, Naming Conventions

Using the Infrared Sensor

The Harmony remote has an infrared sensor at the end opposite to the USB connector. The Harmony remote uses this sensor to learn commands from original device remotes.

•A: Your original remote

•B: Distance between remotes: 5-10 cm (2"-5") apart

•C: Your Harmony remote

The following steps outline what happens when you press a button on your original remote control:

1.The infrared sensor on the Harmony remote learns the infrared signal.

2.The Harmony remote uploads it via the USB cable (and your computer's internet connection) to the Harmony database.

3.The Harmony remote software will try to find a matching pattern for the infrared signal.

4.If no pattern is found, the signal will be stored as-is in its original format.

5.If a pattern is found, the Harmony remote software converts the signal into a format for convenient storage.

Either way, the signal is then available for you to assign to a button on your Harmony remote.

Naming an Infrared Command

When you teach an infrared command to the Harmony remote, give the command a name. This way you can refer to this command by name in various locations of the online setup process. It is best to use the default names listed on the Learn infrared commands step so that automatic button function assignments can be applied to your Harmony remote.

Example

If you teach the volume button infrared commands from your original remote control, name them "VolumeUp" and "VolumeDown" (i.e. with no space, and capitalization as shown). The remote software looks for commands with these names to automatically assign them to the volume up and down buttons on the Harmony remote.

Naming Conventions

When naming a command for which there is no default name on the Learn infrared commands feature, use the following naming conventions to make button assignment and sharing infrared commands easier:

•Do not use spaces or special characters such as /, & or * in the name.

•Capitalize the start of words (e.g. NextDisc, ModeDigital).

•Start the command name with its main function (e.g. VolumeRearUp, VolumeRearDown, VolumeFrontUp, VolumeFrontDown). This helps group related commands in lists.

•For infrared commands that select inputs (e.g. on a stereo receiver), start with the prefix "Input". Do not name the input based on what you have connected to your device, rather name it based on what it is called on the front of the device, or on the remote control (e.g. InputAux, InputVideo1, InputTape, InputDVD, InputVCR).