Using the Drive, Load the disc | Freecom Technologies 400 instruction

Using the Drive

Chapter 3: Using the Drive

How to Use the Discs

Attention! When using CD-ROM, CD-R, CD-RW or DVD R/RW discs, don’t attach any stickers or labels to the discs. Using discs with them attached not only causes read and write errors, but data on the disc may be lost due to damage to the disc itself.

3.1 Load the disc

1.Press the eject button.

2.Place the disc on the disc tray.

Note! When using a 8 cm CD, place it in the small round depression. The face with the label on it should be up. Never place two discs in the tray at the same time.

Be careful not to touch the recording surface of the disc.

3. Load the disc by pressing the eject button or by lightly pushing in the disc tray.

3.2 Disc ejection

1.Press the eject button.

2.Slowly take the disc out of the disc tray.

3.Press the eject button or push the disc tray and the tray will be brought back into the drive.

After ejecting the disc, return the tray inside the unit quickly. When the tray is in the ejected position, dust and other debris will enter, possibly causing read errors, write errors, or drive failure.