Swann P-6T4, SW242-6T4 manual Remote Controller Introduction, Use Remote Controller

Digital Video Recorder User Manual

1	Power plug	2	Alarm in/alarm out
3	RS485	4	USB interface
5	LAN port	6	Audio in 1-2
7	S-video output	8	Audio output
9	Video output	10	Video in 1-4
	Fig2.2 Back Panel

2.4Remote Controller Introduction

2.4.1Use Remote Controller

Notice: Please note that Remote Controller is not a standard part of this DVR. Your package might not include it.

Steps of using the Remote Controller are described as below:

STEP1 Put the battery into the Remote Controller.

1.Open the battery cover of the Remote Controller.

2.Put into two AAA batteries whose model is 7 and make sure that they are not inserted upside down.

3.Put back the battery cover.

STEP2 Check the followings if the Remote Controller does not work.

−Whether the battery’s anode and cathode are in the correct position or not.

−Whether the power of the battery is ran out or not.

−Whether there is barrier between the Remote Controller and DVR or not.

−Whether there are some signals which transmitted by other devices disturbing the Remote Controller or

not.

Notice: If the possibilities above are excluded, please contact with vendor to change the Remote Controller.