MicroBoards Technology Orbit II manual Specifications

Page 37

Orbit II Disc Copier Reference Manual – Revision K

11.4 Specifications

Capacity:

50 CD-Rs

 

Media:

CD-Rs or CD-RWs can be used as masters, or blanks. “Packet format”, which is

 

used on many CD-RW discs, is not supported by the Orbit II Controller. It should

 

also be noted that copying to blank CD-RW discs reduces throughput because the

 

recording operation is slower.

 

Formats:

CD ROM Mode 1

Mixed Mode

 

CD-XA Mode 2 form 1 & 2

Hybrid

 

ISO 9660

HFS

 

UFS

Photo CD

 

CD-DA (Red Book) Single Session

CD-I Bridge

 

CD-Extra / CD Plus / CD-Enhanced

Video CD

 

Multi Session

CD+G Karaoke

 

Note: Packet mode is not supported for CD-Rs or CD-RWs.

 

Masters:

Disc-At-Once

 

 

Session-At-Once

 

 

Track-At-Once

 

Notes:

Discs left open on masters will be left open on the duplicates.

Discs are always written disc at once.

Reliability:

Mean Disc Insertions Between Failure

>200,000

 

MTBF

>10,000 hours

 

MTTR

<30 minutes

Mechanical:

H x W x D

9“ x 18” x 12”

 

 

(23 cm x 46 cm x 30.5 cm)

 

Weight

Shipping 30 lb (13.6 kg)

 

 

Operating without CD-Rs 20 lb (9.1 kg)

Electrical:

External Power Supply 100 – 240 VAC, 50/60 Hz, 1.0/0.5 Amps 100 Watts

Environment:

Temp. – Operating

65 – 85 degrees F (18 – 29 degrees C)

 

Temp. – non Op.

-44–176 degrees F (-40– 80 degrees C)

 

RH Operating

20 – 80 % non-condensing

 

RH Storage

05 – 95 %

Vibration:

Operating

> 0.3 G (5 – 30 Hz)

 

Non-Operating

> 0.5 G (11 msec max.)

Shock:

Operating

> 5 G (11 msec max)

 

Non-Operating

> 50 G (11 msec max)

Altitude:

Operating

10,000 ft (3,048 meters)

 

Non-Operating

30,000 ft (9,144 meters)

37

Image 37 Contents
Orbit II Stand Alone Disc Copier Orbit II Stand Alone 52X Disc Copier Introduction Setting Up your CD-R Copying Area CD-R & CD-RW Media Recommendations CD-R Media Recommendations CD, CD-R, and CD-RW Master Considerations Orbit II Disc Copier Reference Manual Revision K Unpacking the Orbit II and verifying shipment contents Installation & SetupInspecting the shipment for Damage Installing the Orbit Installing the Orbit II Installing the Orbit II Navigating the Orbit II Menu Tree Initial Orbit II Copying System ChecksKey #2 the No key Key #1 the Yes keyOrbit II’s menu structure Navigating the Orbit II Menu Tree System Setup?Burn CD? Must be set to YES To run Copy and Compare Use Buzzer?Loading & Unloading CD-Rs Loading CD-Rs First 5 or 6 CD-Rs Loading Masters Unloading Accepted CD-Rs Unloading Masters Quantity? CD-R Handling TestsWriter and Reader Test System Setup? Use Buzzer? 52x Write?Turn Burn CD? on PromptsCompare? Disc-to-Disc Copy & Compare? Copy DISCtoDISC Basic Orbit II OperationsDisc? Copy ?Copy DISCtoHDD Delete Copy HDDtoDISCCopy and Compare Copy CD+G Compare CDCopy Disc-to-Disc? Copy & Compare? Track Extraction Audio CD Only Batch ModeNext Master? Copy to HD OK?Copy Start / HD01 to Limitations of Track ExtractionSpecial Notes Advanced Orbit II OperationMaintenance Troubleshooting Prior to Calling for Assistance References WarrantyTechnical Support Telephone # Regulatory Agency ApprovalsSpecifications Attachment a The Orbit II Menu Structure Attachment B Orbit II Error Messages