iHome ID84 manual Installing/Replacing Clock Back-up Batteries, Battery Warning, Nap Operation

Using the iD84

Nap Operation

Nap mode lets you set an alarm separate from the Alarm 1 and Alarm 2 settings. The nap wake to source by default is the buzzer alarm, but if an iPad/iPhone/iPod is docked, that will act as the alarm source. If you are listening to the radio or aux-in source, it will be muted and the buzzer will sound at the selected wake time.

1.Press the Nap Button located on top of the unit as needed to adjust the nap timer for 5, 10, 15, 20, 30, 45, 60, 90 or 120 minutes or OFF.

2.To cancel nap mode, press the Nap Button until OFF is displayed. To turn off the nap alarm once it sounds, press the

Button.

Dimmer Operation

During normal operation (when no alarm is sounding), press the Snooze/Dimmer Button to control the brightness of the LCD display.

Using the iD84 in Other Countries

Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the standards in your region (USA, EUROPE, JAPAN, AUSTRALIA,or CHINA). The default setting is USA; if you live in the US, you may skip this section.

1.Make sure the iD84 is OFF (not playing in any mode). Press and hold the Mode Button for about 5 seconds until “Radio xxx” appears in the lower part of display. Press the + or - Button to set the “xxx” to your region.

2.Press the Mode Button again (or no button within 5 seconds) to exit the radio frequency setting mode.

Installing/Replacing Clock Back-up Batteries

We recommend the use of alkaline batteries for longer life.

The iD84 comes with 2 AA back-up batteries installed to provide continuous alarm operation and clock settings in the event of a power failure. When the Battery Low Icon located on the right of the display is flashing, it is time to replace the back-up batteries.

1. Open the battery compartment cover located on the bottom of the unit.

2. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.

3. Insert 2 AA batteries, checking that the polarity (+ and – ends of the battery) matches the drawing near the battery compartment. Close the compartment door.

Note: Make sure you dispose of batteries properly (see your local regulations).

	Battery Warning
For models that require more than one battery
•	Do not mix with used or other battery types/brands	•	Do not heat above 75ºC (167ºF)
•	Replace all batteries at the same time	•	Do not expose contents to water
•	Do not open batteries	•	Do not charge or recharge
•	Do not dispose of in fire	•	Do not install backwards

8