Magnavox CMWD2206 A owner manual Connections, Setup

Setup

Connections

Please refer to “Basic TV Connection” on the front page before you use this unit.

RF Output Channel

If channel 3 has been already occupied for broadcasting,

1)Set your TV to channel 4.

2)Insert a pre-recorded tape into this unit.

3)Press [SOURCE] on the unit so that the VCR SOURCE light is lit.

•If noise appears on the TV screen, press [VCR/TV] on the remote control.

4)Press [PLAY B] once.

5)After a few seconds, press and hold [PLAY B] on the unit for 3 seconds.

•The RF output channel will change to chan- nel 4 from channel 3 and you will see a playback picture.

•When a picture does not appear on the TV screen, repeat step 4.

6)Press [STOP C] to stop playback.

Hint

•The RF output channel does not change when you adjust tracking during playback. In case RF output channel changes, you can easily switch it back. Start the playback again then press and hold

[PLAY B] on the unit for 3 seconds.

Hint for Cable Box or Satellite Box

Setup

	(Cable box or			(Back of DVD/VCR)
	Satellite box)		ANT-IN
Satellite or	IN	OUT	ANT-OUT	RF cable
Cable TV
signal				(supplied)

(Back of TV)

Select this connection when you want to view or record a scrambled channel. With this connection, channels cannot be changed on the unit. You can view or record ONLY the channels you have selected on the cable box or the satellite box.

•While you are recording, only the recorded channel can be viewed.

To select channels of the cable box or satellite box

1)Turn on the unit by pressing [STANDBY-ON], then press [VCR/TV]. The STANDBY-ON indicator on the front panel will light, then press [SKIP/CH. G/K, H/L] to select channel 3 or 4 (the same channel as the output channel of the cable box or satellite box).

•If you use the channel 4, you need to change the unit’s RF output to channel 4. Refer to “RF Output Channel”.

2)At the TV, select channel 3 or 4 (the same channel as you have selected at step 1).

3)On the cable box or satellite box, select the channel you want to view or record.

Connection to an Audio System

Method 1

Stereo system

Audio

LR	Analog audio
	input jacks

Audio cable
(supplied)
	DVD/VCR	VCR
AUDIO OUT	AUDIO OUT
	L
(Analog)	R

DVD/VCRor

DVD

DIGITAL	AUDIO	S-VIDEO	COMPONENT
			VIDEO OUT
AUDIO OUT	OUT	OUT

L

R

(DVD mode only)

Method 2

Dolby Digital decoder,

MD deck or DAT deck

	COAXIAL		Digital audio
			input jack
Audio Coaxial Digital cable
(commercially available)
			DVD
	DIGITAL		AUDIO	S-VIDEO	COMPONENT
					VIDEO OUT
	AUDIO OUT		OUT	OUT
DIGITAL		COAXIAL
AUDIO OUT
Connection		Setting			SETUP > AUDIO >
					DOLBY DIGITAL
Connecting to a Dolby Digital decoder
						BITSTREAM
for Dolby Digital audio output.
Connecting to other equipment (an MD
deck or DAT deck etc.)
							PCM
without Dolby Digital decoder.

* To complete these settings, refer to pages 20-21.

Hint

•The audio source on a disc in a Dolby Digital Multi channel surround format cannot be recorded as digital sound by an MD or DAT deck.

•By hooking this unit up to a Multi channel Dolby Digital decoder, you can enjoy high-quality Dolby Digital Multi channel surround sound as heard in the movie theaters.

•Playing a DVD using incorrect settings may generate noise distortion and may also damage the speakers.

6 EN