Clarion DVS9755z Setting acoustic features Adjust Mode, Selecting adjust mode settings, Dolby D

Control unit button operations

Setting acoustic features (ADJUST MODE)

In this chapter, the control unit buttons are used.

Selecting adjust mode settings

Adjust the settings to suit your sound system.

1.Press the [ADJUST] button to enter the AD-

JUST MODE.

2.Press the [] or [] [DISP] button to select item to set.

Each time the [] or [] [DISP] button is pressed, the indications change as shown below.

Adjust automatic sound format identification

(FORMAT)

Set speaker to on or off

(SP-SEL)

Set speaker filter frequency

(FILTER)

Adjust speaker output level

(SP-GAIN)

Set speaker delay time

(DELAY)

Set Dolby digital

(Dolby D)

Set parametric equalizer

(P.EQ)

Press the [ADJUST] button to return to the

original mode.

•A flow chart is shown on the next page.

*1. The display shows the settings made in the Section, “Changing display settings” (11 page).

*2. When an is displayed at the end of a setting, press the [ENT] button to enter the adjust mode.

*3. When theillustration is shown, press

the indicated button (the [ENT] button in this example).

*4. When [] is displayed to the left of the adjusted value, press the [] or [] [DISP] button to switch the setting.

*5. When the [VOL] buttons are not used within 1 sec, the adjustment value display is switched.

*6. When [] is displayed to the left of the ad- justed value, press the [] or [] [VOL] but- ton to switch the adjustment value.

*7. The next item is displayed.

18 DVS9755z