Clarion DVS9755z Basic Operations, Turning on/off the power, Adjusting the sound volume

7. OPERATION

Basic Operations	Note: Be sure to read this chapter referring to the front diagrams of
	chapter “4. CONTROLS” on page 5 (unfold).

CAUTION

Be sure to lower the volume before switch- ing off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sudden loud volume may hurt your hearing and dam- age the unit.

●ANALOG1 (Analog1):

Use this setting when playing back an analog input source connected using RCA plugs.

●ANALOG2 (Analog 2):

Use this setting when playing back an analog input source connected using a CeNET cable.

Turning on/off the power

Note:

•Be careful about using this unit for a long time with- out running the engine. If you drain the car’s bat- tery too far, you may not be able to start the en- gine and this can reduce the service life of the battery.

1.Press the [POWER] button.

2.The settings are displayed on the control unit display.

3.Press the [POWER] button to turn off the power.

Switching input source

Change the settings to suit the input signal source.

•The initial setting is [INTERNAL]. Press the [SOURCE] button.

Each time the [SOURCE] button is pressed, the indications change as shown below.

[INTERNAL] → [DIGITAL] → [ANALOG1] → [ANALOG2] → [INTERNAL]

•The original mode is resumed when the but- ton is not pressed during a 7 second inter- val.

●INTERNAL (Internal):

Use this setting for playing back DVD videos and CDs.

●DIGITAL (Digital):

Use this setting when playing back CD changer media or other digital input sources connected using an optical-fiber cable.

Adjusting the sound volume

CAUTION

The sound volume on a DVD video disc can become very loud. For that reason, turn up the sound volume gently when the video image is displayed.

Press the [VOL] buttons on the control unit.

:increases the sound volume.

:decreases the sound volume

You can also turn the [VOL] knob on the remote control unit clockwise or counterclockwise.

:increases the sound volume.

:decreases the sound volume

Changing display settings

Press the [] or [] [DISP] button.

Each time the [] or [] [DISP] button are pressed, the indications change as shown be- low.

[PROGRAM] → [SS 1] → [SS 2] → [DISP OFF] → [PROGRAM] →

●PROGRAM (Program):

Displays the sound system used for the DVD video disc.

DVS9755z 11