SIIG CEMT0A12S1 Wall Plate Installation, Wood Stud Installation, Concrete/Brick Wall Installation

Page 2

Step 1: Wall Plate Installation

Wood Stud Installation

1Use a high-quality electronic stud finder (commercially available) to locate dead center of the wood stud and mark the location with a pencil.

2Hold the wall plate (Figure 1) to the wall, use the two mounting holes to mark the locations to be used for mounting the wall plate.

3Take down the wall plate and drill two 2" deep holes, using a 1/8" drill bit at the positions you've marked.

4Attach the wall plate to the wall again and insert the bolts (A) and washers (D) into the holes (Figure 1) and tighten.

Figure 1

Figure 2

Concrete/Brick Wall Installation

1Hold the wall plate (Figure 2) to the wall, use the two mounting holes to mark the locations to be used for mounting the wall plate. Locate the holes directly into the brick, block or concrete, never into the mortar between the blocks.

2Pre-drill two holes to a depth of 2" using a 3/8" masonry drill bit at the positions you've marked and insert one concrete anchor (B) into each hole.

3Position the wall plate onto the wall again and insert the bolts (A) and washer (D) into the anchor as shown (Figure 2) and tighten.

Page 2

Image 2
Contents LCD TV/Monitor Tilting Mount 10 to Concrete/Brick Wall Installation Wall Plate InstallationWood Stud Installation Display Plate Installation Final InstallationMaintenance Blank Blank Technical Support and Warranty About SIIG, Inc Product Name