LG Electronics 50PG25, 60PG60, 5270, 5260, 50PG60, 4770, 4760, 42PG25, 4270, 4260, 4230, 4250, 3760, 3750 148

Page 150

APPENDIX

APPENDIX

7. DISCLAIMER OF WARRANTY.

COVERED CODE IS PROVIDED UNDER THIS LICENSE ON AN “AS IS” BASIS, WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, WARRANTIES THAT THE COV- ERED CODE IS FREE OF DEFECTS, MERCHANTABLE, FIT FOR A PARTICULAR PURPOSE OR NON-INFRINGING. THE ENTIRE RISK AS TO THE QUALITY AND PERFOR- MANCE OF THE COVERED CODE IS WITH YOU. SHOULD ANY COVERED CODE PROVE DEFECTIVE IN ANY RESPECT, YOU (NOT THE INITIAL DEVELOPER OR ANY OTHER CONTRIBUTOR) ASSUME THE COST OF ANY NECESSARY SERVICING, REPAIR OR CORRECTION. THIS DISCLAIMER OF WARRANTY CONSTITUTES AN ESSENTIAL PART OF THIS LICENSE. NO USE OF ANY COVERED CODE IS AUTHORIZED HEREUNDER EXCEPT UNDER THIS DISCLAIMER.

8. TERMINATION.

8.1.This license and the rights granted hereunder will terminate automatically if you fail to comply with terms herein and fail to cure such breach within 30 days of becoming aware of the breach. All sublicenses to the covered code which are properly granted shall survive any termination of this license. Provisions which, by their nature, must remain in effect beyond the termination of this license shall survive.

8.2.If you initiate litigation by asserting a patent infringement claim (excluding declatory judgment actions) against ini- tial developer or a contributor (the initial developer or contributor against whom you file such action is referred to as “Participant”) alleging that:

(a)such participant's contributor version directly or indi- rectly infringes any patent, then any and all rights granted by such participant to you under sections 2.1 and/or 2.2 of this license shall, upon 60 days notice from Participant terminate prospectively, unless if within 60 days after receipt of notice you either: (i) agree in writing to pay participant a mutually agreeable reasonable royalty for your past and future use of modifications made by such participant, or (ii) withdraw your litigation claim with respect to the contributor version against such participant. If within 60 days of notice, a reasonable royalty and payment arrangement are not mutually agreed upon in writing by the parties or the litigation claim is not withdrawn, the rights granted by partici- pant to you under sections 2.1 and/or 2.2 automati- cally terminate at the expiration of the 60 day notice period specified above.

(b)any software, hardware, or device, other than such par- ticipant's contributor Version, directly or indirectly infringes any patent, then any rights granted to You by

such participant under sections 2.1(b) and 2.2(b) are revoked effective as of the date you first made, used, sold, distributed, or had made, modifications made by that participant.

8.3.If you assert a patent infringement claim against partici- pant alleging that such participant's contributor version directly or indirectly infringes any patent where such claim is resolved (such as by license or settlement) prior to the initiation of patent infringement litigation, then the rea- sonable value of the licenses granted by such participant under sections 2.1 or 2.2 shall be taken into account in determining the amount or value of any payment or license.

8.4.In the event of termination under sections 8.1 or 8.2 above, all end user license agreements (excluding distributors and resellers) which have been validly granted by you or any distributor hereunder prior to termination shall survive termination.

9. LIMITATION OF LIABILITY.

UNDER NO CIRCUMSTANCES AND UNDER NO LEGAL THEORY, WHETHER TORT (INCLUDING NEGLIGENCE), CONTRACT, OR OTHERWISE, SHALL YOU, THE INITIAL DEVELOPER, ANY OTHER CONTRIBUTOR, OR ANY DIS- TRIBUTOR OF COVERED CODE,OR ANY SUPPLIER OF ANY OF SUCH PARTIES, BE LIABLE TO ANY PERSON FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUEN- TIAL DAMAGES OF ANY CHARACTER INCLUDING, WITH- OUT LIMITATION, DAMAGES FOR LOSS OF GOODWILL, WORK STOPPAGE, COMPUTER FAILURE OR MALFUNC- TION, OR ANY AND ALL OTHER COMMERCIAL DAM- AGES OR LOSSES, EVEN IF SUCH PARTY SHALL HAVE BEEN INFORMED OF THE POSSIBILITY OF SUCH DAM- AGES. THIS LIMITATION OF LIABILITY SHALL NOT APPLY TO LIABILITY FOR DEATH OR PERSONAL INJURY RESULT- ING FROM SUCH PARTY'S NEGLIGENCE TO THE EXTENT APPLICABLE LAW PROHIBITS SUCH LIMITATION. SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAM- AGES, SO THIS EXCLUSION AND LIMITATION MAY NOT APPLY TO YOU.

10. U.S. GOVERNMENT END USERS.

The covered code is a "commercial item," as that term is defined in 48 C.F.R. 2.101 (Oct. 1995), consisting of "commercial computer software" and "commercial computer software documentation," as such terms are used in 48 C.F.R. 12.212 (Sept. 1995). Consistent with 48 C.F.R. 12.212 and 48 C.F.R. 227.7202-1 through 227.7202-4 (June 1995), all U.S. Government end users acquire cov- ered code with only those rights set forth herein.

148

Image 150
Contents LCD TV Plasma TV Page FCC Notice Safety Instructions Important Safety InstructionsDisconnecting Device from Mains Exposed to dripping or splashing and noGrounding Contents Clock Setting External Control Through RS-232CFeature of this TV On DisposalPreparation AccessoriesPreparation 4EA32/42/47/52LG70 VolumeFront Panel Information Input MenuVolume + 32/37/42/47/52LG60Back Panel Information 32/37/42LG30 37/42/47/52LG5032/42/47/52LG70 Image shown may differ from your TVDigital Audio OUT Audio RGB/DVIANTENNA/CABLE Audio OUTOnly 32/37/42LG30, 37/42LG50, 32/42LG70 Stand InstallationOnly 42PG25 Stand BodyOnly 32/37/42LG60 Stand Body Cover BaseBack of the TV 42PG25 How to remove the Cable Management ClipCable Management 50PG25, 50/60PG6032/37/42LG30, 37/42/47/52LG50, 32/42/47/52LG70 Connect the cables as necessaryDesktop Pedestal Installation Swivel StandVesa Wall Mounting 32/37/42LG30, 37/42/47/52LG50Protection Cover Insert the Protection Cover into the TV until clicking soundSecuring the TV to the Wall to Prevent Falling Ensure the eye-bolts or brackets are tightened securelyAntenna or Cable Connection Antenna Analog or DigitalHow to connect External Equipment SetupHD Receiver Setup How to useExternal Equipment Setup Plasma TV, 32/37/42LG30, 37/42/47/52LG50, 32/42/47/52LG70Hdmi Connection HDMI-DTVPlasma TV, 32/42/47/52LG70 DVI to Hdmi Connection 32/37/42LG30, 37/42/47/52LG50, Plasma TVRGB HDMI/DVI DVD Setup Component Input portsRGB Rgbpc Digita Equipment Setup ExternalTurn on the DVD player, insert a DVD 32/37/42/47/52LG60 Equipment VCR SetupAntenna Connection Antenna in socket of the VCRSelect the AV1 input source on the TV using the Input Composite RCA ConnectionAntenna Cable Digital Audio OUT Other A/V Source Setup CamcorderPC Setup VGA D-Sub 15 pin ConnectionExternal Equipment Setup External 59.94 800x600 Only RGB-PC mode63.981 79.976 47.712 75.00 66.587 67.5 Only RGB-PC mode 59.87800x600 37.879 31.468720x400 31.469 48.363 60.00Screen Setup for PC mode Selecting ResolutionSelect Picture Can adjust the Position, S i z e or Phase Auto ConfigureSelect Auto config Select YesAdjustment for screen Position, Size, and Phase Screen Reset Reset to original factory values Select ResetUSB Connection Except 32/37/42LG30 Digital SetupAudio OUT Connection External EquipmentWatching TV / Channel Control Remote Control FunctionsMute Switch the sound on or off. G p.50 Watching TV / ChannelInstalling Batteries Watching TV / Channel ControlVolume Adjustment Turning on the TVChannel Selection USB Eject Select USB Eject in order to eject USB device Display each menu Make appropriate adjustmentsQuick Menu Return to TV viewingTime setting Initial SettingMode setting ControlStart Auto Tuning Option settingAuto Tuning You can also adjust Initial Setting in the Option menuTV / Channel Control ON-SCREEN Menus SelectionWatching Display each menuFor USA Only for 32/37/42LG30Channel Setup Auto Scan Auto TuningSelect Channel Select DTV, T V, CADTV, or Catv Add/Delete Channel Manual TuningSelect Manual Tuning Is turned on Select channel you want to add or deleteChannel Editing Input List Input Label With using Option menuWith using Input button Watching TVAV Mode You can select the optimal images and soundsSelect Option Simplink Functions Simplink MenuUSB Entry ModesUSB Screen Components Corresponding buttons on the remote controlPhoto List Select USB Moves to upper level file Preview DisplayShow the Popup menu Photo Selection and Popup MenuSelect the desired photos Use the CH button to navigation in the photoFull Screen Menu Select the Sideshow, BGM, Rotate Music List Select USB Select Music ListSelect the desired musics Music Selection and Popup MenuUp to 6 music titles are listed per Use the CH button to navigation in the musicUSB Picture Control Picture Size Aspect Ratio ControlPicture Control Zoom Set by program169 Just ScanSelect Picture Mode Preset Picture SettingsPicture Mode Preset You can also adjust Picture Mode in the Q. MenuColor Tone Preset Advanced ControlGammaManual Picture Adjustment Picture Mode User ModeBrightness, Sharpness, Color, or Tint Picture Mode Expert Control PicturePicture Improvement Technology Advanced Control GammaSelect Black Level Advanced Control Black Darkness LevelSelect Advanced Control Select Low or HighAdvanced Control EYE Care LCD TV Only Select Real Cinema or Film Advanced Control Real Cinema / Film ModeSelect Picture Select O n or Off ModeAdvanced Control Trumotion Only 32/37/42/47/52LG60, 32/42/47/52LG70Select TruMotion Demo Begin TruMotion DemoStop TruMotion Demo Picture Reset Initialize the adjusted valueStandby Light You can set TV during power standbyUme On or off while watching the TVInversion or White Wash Select ISM MethodSelect Normal, Orbiter Return to TV viewing WhitePower Saving Picture Mode Plasma TV Only It reduces the plasma display’s power consumptionSound & Language Control Auto Volume Leveler Auto VolumeSelect Auto Volume Sound & Language ControlYou can also adjust Sound Mode in the Q. Menu Preset Sound Settings Sound ModeSelect Sound Mode Select Standard, MusicCinema, Sport, or Game Sound Setting Adjustment User ModeAdjust the sound to suit your taste and room situations Select Treble or BassClear Voice SoundLanguage Control Balance TV Speakers ON/OFF Setup Turn the TV speakers off if using external audio equipmentAudio Reset Digital TV STEREO/SAP Broadcast SetupAnalog TV Plasma TVAudio Language Select your desired language English, Spanish, or FrenchSelect Language Select Menu Select your desired language ON-SCREEN Menus Language SelectionMenus can be shown on the screen in the selected language Return to the previous menu Return to TV viewingCaption Caption ModeAnalog Broadcasting System Captions TextSelect CC1-4, Text1-4, or Service1 Digital Broadcasting System CaptionsCaption Option Size Set the word sizeAuto Clock Setup Time SettingClock Setting Time SettingManual Clock Setup If the current time setting is wrong, set the clock manuallySelect Off time or On Time Auto ON/OFF Time SettingWhen Selecting T Set the channel at turn-on Select and set Hour or MinuteSelect Off, 1 0, 2 0, 3 0, 6 0, 9 Sleep Timer SettingSelect Time Select Sleep Timer 120, 180, or 240 minutesAuto SHUT-OFF Setting Parental Control / Ratings SET Password & Lock SystemSetting up Your Password Chip rating and categoriesSelect Lock System Is enableLock System Parental Control / RatingSelect Set password Set PasswordChange the password by inputting a new password twice Same 4 digits on the ConfirmChannel Blocking Select Block ChannelMovie Rating Mpaa For USA only Select Lock Input the password General audienceMovie & TV Rating PG-13 Parents strongly cautionedTV Rating Children For USA only TV Rating General For USA only TV Rating English For Canada only ParentalControl / Rating Selecting canadian french language rating system Select Lock Exempt Input the password GeneralTV Rating French For Canada only Select E, G, 8ans+, 13ans+Downloadable Rating Downloadable RatingEnables you to block an input External Input BlockingKEY Lock Appendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixHDMI/USB No sound When connectingPicture OK & No sound No output from one Speakers Vertical bar or stripe on BackgroundCleaning the Cabinet MaintenanceCleaning the Screen Extended AbsenceProduct Specifications 42LG30122 123 Programming the Remote Control Testing your remote controlRemote Control Code VCRHdstb IR Codes Remote Control IR CodesConfiguration of frame Output waveform128 RS-232C Setup Communication ParametersGND RS-232C Configurations Either cable below can be usedRXD TXD GND DTR DSR RTS CTS Command Reference List Transmission / Receiving Protocol132 133 134 135 GNU General Public License Version 2, June137 138 139 GNU Lesser General Public License 141 142 143 144 Mozilla Public License 146 147 148 149
Related manuals
Manual 2 pages 12.89 Kb