LG Electronics 50PG60, 60PG60, 5270, 5260, 4770, 4760, 42PG25, 4270, 4260, 4230, 4250, 3760, 3750 FCC Notice

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions in the litera- ture accompanying the appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

 

 

 

CAUTION

 

 

 

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Image 3
Contents LCD TV Plasma TV Page FCC Notice Important Safety Instructions Safety InstructionsDisconnecting Device from Mains Exposed to dripping or splashing and noGrounding Contents External Control Through RS-232C Clock SettingOn Disposal Feature of this TV4EA AccessoriesPreparation PreparationInput Menu VolumeFront Panel Information 32/42/47/52LG7032/37/42/47/52LG60 Volume +Back Panel Information 37/42/47/52LG50 32/37/42LG30Image shown may differ from your TV 32/42/47/52LG70Audio OUT Audio RGB/DVIANTENNA/CABLE Digital Audio OUTStand Body Stand InstallationOnly 42PG25 Only 32/37/42LG30, 37/42LG50, 32/42LG70Only 32/37/42LG60 Stand Body Cover BaseBack of the TV 50PG25, 50/60PG60 How to remove the Cable Management ClipCable Management 42PG25Connect the cables as necessary 32/37/42LG30, 37/42/47/52LG50, 32/42/47/52LG70Swivel Stand Desktop Pedestal Installation32/37/42LG30, 37/42/47/52LG50 Vesa Wall MountingInsert the Protection Cover into the TV until clicking sound Protection CoverEnsure the eye-bolts or brackets are tightened securely Securing the TV to the Wall to Prevent FallingAntenna Analog or Digital Antenna or Cable ConnectionHow to use External Equipment SetupHD Receiver Setup How to connectPlasma TV, 32/37/42LG30, 37/42/47/52LG50, 32/42/47/52LG70 External Equipment SetupHDMI-DTV Hdmi ConnectionPlasma TV, 32/42/47/52LG70 32/37/42LG30, 37/42/47/52LG50, Plasma TV DVI to Hdmi ConnectionRGB HDMI/DVI Component Input ports DVD SetupRGB Rgbpc Digita Equipment Setup ExternalTurn on the DVD player, insert a DVD 32/37/42/47/52LG60 Antenna in socket of the VCR VCR SetupAntenna Connection EquipmentComposite RCA Connection Select the AV1 input source on the TV using the InputAntenna Cable Digital Audio OUT Camcorder Other A/V Source SetupVGA D-Sub 15 pin Connection PC SetupExternal Equipment Setup External 59.87 Only RGB-PC mode63.981 79.976 47.712 75.00 66.587 67.5 Only RGB-PC mode 59.94 800x60048.363 60.00 31.468720x400 31.469 800x600 37.879Screen Setup for PC mode Selecting ResolutionSelect Picture Select Yes Auto ConfigureSelect Auto config Can adjust the Position, S i z e or PhaseAdjustment for screen Position, Size, and Phase Select Reset Screen Reset Reset to original factory valuesUSB Connection Except 32/37/42LG30 External Equipment SetupAudio OUT Connection DigitalWatching TV / Channel Remote Control FunctionsMute Switch the sound on or off. G p.50 Watching TV / Channel ControlWatching TV / Channel Control Installing BatteriesVolume Adjustment Turning on the TVChannel Selection Return to TV viewing Display each menu Make appropriate adjustmentsQuick Menu USB Eject Select USB Eject in order to eject USB deviceControl Initial SettingMode setting Time settingYou can also adjust Initial Setting in the Option menu Option settingAuto Tuning Start Auto TuningDisplay each menu ON-SCREEN Menus SelectionWatching TV / Channel ControlOnly for 32/37/42LG30 For USAChannel Setup Auto Scan Auto TuningSelect Channel Is turned on Select channel you want to add or delete Add/Delete Channel Manual TuningSelect Manual Tuning Select DTV, T V, CADTV, or CatvChannel Editing Input List Watching TV With using Option menuWith using Input button Input LabelYou can select the optimal images and sounds AV ModeSelect Option Simplink Menu Simplink FunctionsUSB Entry ModesUSB Select USB Moves to upper level file Preview Display Corresponding buttons on the remote controlPhoto List Screen ComponentsUse the CH button to navigation in the photo Photo Selection and Popup MenuSelect the desired photos Show the Popup menuFull Screen Menu Select the Sideshow, BGM, Rotate Select USB Select Music List Music ListUse the CH button to navigation in the music Music Selection and Popup MenuUp to 6 music titles are listed per Select the desired musicsUSB Picture Control Picture Size Aspect Ratio ControlPicture Control Just Scan Set by program169 ZoomYou can also adjust Picture Mode in the Q. Menu Preset Picture SettingsPicture Mode Preset Select Picture ModeAdvanced ControlGamma Color Tone PresetManual Picture Adjustment Picture Mode User ModeBrightness, Sharpness, Color, or Tint Picture Picture Mode Expert ControlAdvanced Control Gamma Picture Improvement TechnologySelect Low or High Advanced Control Black Darkness LevelSelect Advanced Control Select Black LevelAdvanced Control EYE Care LCD TV Only Mode Advanced Control Real Cinema / Film ModeSelect Picture Select O n or Off Select Real Cinema or FilmOnly 32/37/42/47/52LG60, 32/42/47/52LG70 Advanced Control TrumotionSelect TruMotion Demo Begin TruMotion DemoStop TruMotion Demo Initialize the adjusted value Picture ResetOn or off while watching the TV TV during power standbyUme Standby Light You can setReturn to TV viewing White Select ISM MethodSelect Normal, Orbiter Inversion or White WashIt reduces the plasma display’s power consumption Power Saving Picture Mode Plasma TV OnlySound & Language Control Auto Volume Leveler Auto VolumeSelect Auto Volume Sound & Language ControlSelect Standard, Music Preset Sound Settings Sound ModeSelect Sound Mode You can also adjust Sound Mode in the Q. MenuSelect Treble or Bass Sound Setting Adjustment User ModeAdjust the sound to suit your taste and room situations Cinema, Sport, or GameClear Voice SoundLanguage Control Balance Turn the TV speakers off if using external audio equipment TV Speakers ON/OFF SetupAudio Reset Plasma TV STEREO/SAP Broadcast SetupAnalog TV Digital TVSelect your desired language English, Spanish, or French Audio LanguageReturn to the previous menu Return to TV viewing ON-SCREEN Menus Language SelectionMenus can be shown on the screen in the selected language Select Language Select Menu Select your desired languageText Caption ModeAnalog Broadcasting System Captions CaptionDigital Broadcasting System Captions Select CC1-4, Text1-4, or Service1Size Set the word size Caption OptionTime Setting Time SettingClock Setting Auto Clock SetupIf the current time setting is wrong, set the clock manually Manual Clock SetupSelect and set Hour or Minute Auto ON/OFF Time SettingWhen Selecting T Set the channel at turn-on Select Off time or On Time120, 180, or 240 minutes Sleep Timer SettingSelect Time Select Sleep Timer Select Off, 1 0, 2 0, 3 0, 6 0, 9Auto SHUT-OFF Setting Chip rating and categories SET Password & Lock SystemSetting up Your Password Parental Control / RatingsParental Control / Rating Is enableLock System Select Lock SystemSame 4 digits on the Confirm Set PasswordChange the password by inputting a new password twice Select Set passwordSelect Block Channel Channel BlockingPG-13 Parents strongly cautioned Select Lock Input the password General audienceMovie & TV Rating Movie Rating Mpaa For USA onlyTV Rating Children For USA only TV Rating General For USA only TV Rating English For Canada only ParentalControl / Rating Select E, G, 8ans+, 13ans+ Select Lock Exempt Input the password GeneralTV Rating French For Canada only Selecting canadian french language rating systemDownloadable Rating Downloadable RatingExternal Input Blocking Enables you to block an inputKEY Lock Appendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixVertical bar or stripe on Background No sound When connectingPicture OK & No sound No output from one Speakers HDMI/USBExtended Absence MaintenanceCleaning the Screen Cleaning the Cabinet42LG30 Product Specifications122 123 Testing your remote control Programming the Remote ControlVCR Remote Control CodeHdstb Output waveform Remote Control IR CodesConfiguration of frame IR Codes128 RS-232C Setup Communication ParametersGND RS-232C Configurations Either cable below can be usedRXD TXD GND DTR DSR RTS CTS Transmission / Receiving Protocol Command Reference List132 133 134 135 Version 2, June GNU General Public License137 138 139 GNU Lesser General Public License 141 142 143 144 Mozilla Public License 146 147 148 149
Related manuals
Manual 2 pages 12.89 Kb