LG Electronics 60PB5600 owner manual TV screen, YyDot Defect For USA and Canada, YyGenerated Sound

				IMPORTANT SAFETY INSTRUCTIONS	5
yyDot Defect			For USA and Canada
	The panel is a high technology product with
	resolution of two million to six million pixels.
				FCC NOTICE
	In a very few cases, you could see fine dots
	on the screen while you’re viewing the TV.		This equipment has been tested and found
	Those dots are deactivated pixels and do not
			to comply with the limits for a Class B
	affect the performance and reliability of the
			digital device, pursuant to Part 15 of the
	TV.
			FCC Rules. These limits are designed to
yyGenerated Sound
			provide reasonable protection against harmful
	Cracking noise: A cracking noise that occurs
			interference in a residential installation.
	when watching or turning off the TV is
			This equipment generates, uses and can
	generated by plastic thermal contraction
			radiate radio frequency energy and, if not
	due to temperature and humidity. This noise
			installed and used in accordance with the
	is common for products where thermal
			instructions, may cause harmful interference
	deformation is required.
			to radio communications. However, there is
	Electrical circuit humming/panel buzzing: A
			no guarantee that interference will not occur
	low level noise is generated from a high-
			in a particular installation. If this equipment
	speed switching circuit, which supplies a
			does cause harmful interference to radio or
	large amount of current to operate a product.
			television reception, which can be determined
	It varies depending upon the product.
			by turning the equipment off and on, the user
	This generated sound does not affect the
			is encouraged to try to correct the interference
	performance and reliability of the product.
			by one or more of the following measures:
yyTake care not to touch the ventilation
			- Reorient or relocate the receiving antenna.
	openings. When watching the TV for a long
	period, the ventilation openings may become		- Increase the separation between the
	hot. This does not affect the performance of			equipment and the receiver.
	the product or cause defects in the product.		- Connect the equipment to an outlet on
				a circuit different from that to which the
				receiver is connected.
			- Consult the dealer or an experienced
				radio/TV technician for help.
			This device complies with part 15 of the FCC
	Preventing	image burn or burn-in on your
			Rules. Operation is subject to the following
TV screen
			two conditions: (1) this device may not cause
			harmful interference and (2) this device must
			accept any interference received, including
			interference that may cause undesired
			operation of the device.
			Any changes or modifications in construction
yyIf a fixed image displays on the TV screen for			of this device which are not expressly
			approved by the party responsible for
	a long period of time, it will be imprinted and
			compliance could void the user’s authority to
	become a permanent disfigurement on the
			operate the equipment.
	screen. This is image burn or burn-in and not
	covered by the warranty.		NOTE TO CABLE/TV INSTALLER
yyIf the aspect ratio of the TV is set to 4:3 for a

long period of time, image burn may occur on	This reminder is provided to call the CATV
the letterboxed area of the screen.
	system installer’s attention to Article 820-
yyAvoid displaying a fixed image on the TV
	40 of the National Electric Code (U.S.A.).
screen for a long period of time (2 or more
	The code provides guidelines for proper
hours for LCD, 1 or more hours for the
	grounding and, in particular, specifies that
Plasma TV) to prevent image burn.
	the cable ground shall be connected to the
	grounding system of the building, as close to
	the point of the cable entry as practical.

ENGLISH