LG Electronics 50PG10, 42PG10 owner manual FCC Notice

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions in the litera- ture accompanying the appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

 

 

 

CAUTION

 

 

 

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Image 3
Contents 42PG10 50PG10 42PG20 50PG20 42PG20C 50PG20C 50PG30 60PG30 Page FCC Notice Important Safety Instructions Safety InstructionsDisconnecting Device from Mains Exposed to dripping or splashing and noGrounding Contents Auto Volume Leveler Auto Volume Clock SettingExternal Control Through RS-232C Feature of this TV Accessories PreparationPreparation Front Panel Information Power Input MenuVolume Channel VolumeBack Panel Information Stand Installation Only 42PG10/20/20C Cable Management How to remove the Cable Management ClipSwivel Stand Only 50/60PG30 Desktop Pedestal InstallationProtection Cover Vesa Wall MountingSame Securing the TV to the Wall to Prevent FallingAntenna Analog or Digital Antenna or Cable ConnectionHow to use External Equipment SetupHD Receiver Setup How to connectSetup Hdmi ConnectionHDMI-DTV Audio RGB/DVI jack on the TV DVI to Hdmi ConnectionConnect the DVI output of the digital set-top box to HDMI/DVI IN1, 2, or Hdmi IN3 jack onExternal Equipment DVD SetupConnect the audio outputs of the DVD to Component in AUDIO1 jacks on the TVInput jacks on the TV Video ConnectionConnect the S-VIDEO output of the DVD to Video input on the TVAntenna Connection VCR SetupComposite RCA Connection Port of Digital Audio OUT Other A/V Source SetupAudio OUT Connection Connect the AUDIO/VIDEO jacksRGB/DVI jack on the TV PC SetupConnect the PC audio output to Audio37.861 31.468720x400 31.469 37.500External Screen Setup for PC modeSelecting Resolution Equipment SetupSelect Auto config Auto ConfigureAdjustment for screen Position, Size, and Phase Screen Reset Reset to original factory values Select ResetSelect Yes Remote Control Functions Watching TV / Channel Control Installing BatteriesVolume Adjustment Turning on TVChannel Selection Auto Tuning Initial SettingMode Setting Time SettingChannel Control Display each menu Make appropriate adjustmentsQuick Menu Watching TVDisplay each menu ON-SCREEN Menus SelectionTV / Channel Control For USASelect Channel Channel SetupAuto Scan Auto Tuning Watching TV / ChannelSelect Add or Delete Add/Delete Channel Manual TuningSelect Manual Tuning Select channel you want to add or deleteChannel Editing Select the desired input source Input ListSelect Input Label With using Option menuWith using Input button Input LabelYou can select the optimal images and sounds AV ModeWatching TV / Channel Select OptionSimplink Menu Simplink FunctionsPicture Control Picture Size Aspect Ratio ControlPicture Control 169 Picture Mode Preset Preset Picture SettingsColor Tone Preset Manual Picture Adjustment Picture Mode User ModePicture Off Picture Mode Standard Picture Mode Expert ControlPicture Improvement Technology Low The reflection of the screen gets Darker Advanced Control Black Darkness LevelAdvanced Control Film Mode Initialize the adjusted value Picture ResetWhite Wash White Wash removes Image Sticking Minimization ISM MethodUtes Every 30 minutesIt reduces the plasma display’s power consumption Power Saving Picture ModeSound & Language Control Auto Volume Leveler Auto VolumeSelect Auto Volume Sound & Language ControlClear Voice SoundLanguage Control Sound Select Standard, Music, Cinema, Sport, or Game Preset Sound Settings Sound ModeSelect Standard, Music Sound Setting Adjustment User ModeAdjust the sound to suit your taste and room situations Select Sound ModeBalance Turn the TV speakers off if using external audio equipment TV Speakers ON/OFF SetupAudio Reset STEREO/SAP Broadcast Setup Analog TVDigital TV Select your desired language English, Spanish, or French Audio LanguageReturn to the previous menu Return to TV viewing ON-SCREEN Menus Language SelectionMenus can be shown on the screen in the selected language Select Language Select Menu Select your desired languageText Caption ModeAnalog Broadcasting System Captions CaptionDigital Broadcasting System Captions Select CC1-4, Text1-4, or Service1Size Set the word size Caption OptionTime Setting Time SettingClock Setting Auto Clock SetupIf the current time setting is wrong, set the clock manually Manual Clock SetupSelect Off time or On time Auto ON/OFF Time SettingSelect Time Only for On Time functionSleep Time turns the TV off at the preset time Sleep Timer SettingAuto SHUT-OFF Setting Chip rating and categories SET Password & Lock SystemSetting up Your Password Parental Control / RatingsIs enable Lock SystemSelect Lock System Set Password ParentalControl / Rating Block Channel Channel BlockingPG-13 Parents strongly cautioned Select Lock Input the password General audienceMovie & TV Rating Movie Rating Mpaa For USA onlyTV Rating Children For USA only TV Rating General For USA only Select TV Rating-English TV Rating English For Canada onlySelecting canadian english language rating system Select Lock16ans+, 18ans+, or Blocking off TV Rating French For Canada onlySelecting canadian french language rating system Select E, G, 8ans+, 13ans+Downloadable Rating External Input Blocking Enables you to block an inputKEY Lock Appendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixVertical bar or stripe on Background Audio function does not workCleaning the Cabinet MaintenanceProduct Specifications Cleaning the Screen60PG30 Repeat frame Remote Control IR CodesIR Codes 1st frameCode Function GND RS-232C SetupExternal Control Through RS-232C Communication ParametersRS-232C Configurations Either cable below can be usedRXD TXD GND DTR DSR RTS CTS Transmission / Receiving Protocol Command Reference ListSet ID DataCr Transmission km Set ID DataCr Step
Related manuals
Manual 118 pages 59.2 Kb Manual 118 pages 59.2 Kb