Connecting to an Antenna or Cable

NOTE

••If you record a TV program on a DVD recorder or VCR, make sure to connect the TV signal input cable to the TV through a DVD recorder or VCR. For more information about recording, refer to the manual provided with the connected device.

••The external device connections shown may differ slightly from illustrations in this manual.

••Connect external devices to the TV regardless about the order of the TV port.

••If you connect a gaming device to the TV, use the cable supplied with the gaming device.

••Refer to the external equipment’s manual for operating instructions.

Connect an antenna, cable, or cable box to watch TV while referring to the following. The illustrations may differ from the actual items and an RF cable is optional.

CAUTION

••Make sure not to bend the copper wire of the RF cable.

Copper wire

••Complete all connections between devices, and then connect the power cord to the power outlet to prevent damage to your TV.

NOTE

••Use a signal splitter to use 2 TVs or more.

••DTV Audio Supported Codec: MPEG, Dolby Digital.

Other Connections

Connect your TV to external devices. For the best picture and audio quality, connect the external device and the TV with the HDMI cable.

Remote Control

(Image shown may differ from your TV.)

The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To install batteries, open the battery cover, replace batteries (1.5 V AAA) matching the and ends to the label inside the compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient pollution. To remove the batteries, perform the installation actions in reverse. This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote sensor.