••Do not use high voltage electrical equipment near the TV, (e.g., a bug zapper.)
This may result in product malfunction.
••Dot Defect
The panel is a high technology product with resolution of two million to six million pixels. In a very few cases, you could see fine dots on the screen while you’re viewing the TV. Those dots are deactivated pixels and do not affect the performance and reliability of the TV.
••Generated Sound
Cracking noise A cracking noise that occurs when watching or turning off the TV is generated by plastic thermal contraction due to temperature and humidity. This noise is common for products where thermal deformation is required.
Electrical circuit humming/panel buzzing A low level noise is generated from a high- speed switching circuit, which supplies a large amount of current to operate a product. It varies depending upon the product. This generated sound does not affect the performance and reliability of the product.
••Take care not to touch the ventilation openings. When watching the TV for a long period, the ventilation openings may become hot. This does not affect the performance of the product or cause defects in the product.
••Do not install this product on a wall if it could be exposed to oil or oil mist. This may damage the product and cause it to fall.
••If the TV feels cold to the touch, there may be a small flicker when it is turned on. This is normal; there is nothing wrong with TV. Some minute dot defects may be visible on the screen, appearing as tiny red, green, or blue spots. However, they have no adverse effect on the TV’s performance. Avoid touching the LCD screen or holding your finger(s) against it for long periods of time. Doing so may produce some temporary distortion effects on the screen.
••Preventing Image Burn or Burn-in on Your TV
Screen
••If a fixed image displays on the TV screen for a long period of time, it will be imprinted and become a permanent disfigurement on the screen. This is image burn or
••If the aspect ratio of the TV is set to 4:3 for a long period of time, image burn may occur on the letterboxed area of the screen.
••Avoid displaying a fixed image on the TV screen for a long period of time (2 or more hours for LCD, 1 or more hours for the plasma TV) to prevent image burn.
FCC NOTICE
(For USA) |
| |
This equipment has been tested and found to |
| |
comply with the limits for a Class B digital device, |
| |
pursuant to Part 15 of the FCC Rules. These limits | ENGLISH | |
are designed to provide reasonable protection | ||
| ||
against harmful interference in a residential |
| |
installation. This equipment generates, uses |
| |
and can radiate radio frequency energy and, if |
| |
not installed and used in accordance with the |
| |
instructions, may cause harmful interference |
| |
to radio communications. However, there is no |
| |
guarantee that interference will not occur in a |
| |
particular installation. If this equipment does |
| |
cause harmful interference to radio or television |
| |
reception, which can be determined by turning |
| |
the equipment off and on, the user is encouraged |
| |
to try to correct the interference by one or more of |
| |
the following measures: |
|
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
5