Installation
External Equipment Connections
Antenna Connection
- For optimum picture quality, adjust antenna direction.
Connecting to an Inside Antenna Setup
-Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below. (Use the correct type of antenna cable for the type of wall antenna jack.)
| Turn clockwise to tighten. | |
| 75Ω Round Cable | Copper Wire |
|
| |
| 300Ω Flat Wire |
|
|
| Antenna |
Apartment Buildings | Wall Connection Jack | Converter |
| ||
|
| |
UT |
| ANT IN ( |
|
|
| 75 ) |
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Antenna Jack
-If you have a 75Ω round cable, insert the bronze wire and then tighten the connection nut. If you have a 300Ω flat wire, connect the twisted wire to the antenna converter and then connect the converter to the antenna jack on the TV.
-If using 75Ω round cable, do not bend the bronze wire. It may cause poor picture quality.
Connecting to an Outdoor Antenna Setup
- This type of antenna is commonly used in single family dwellings.
| VHF Antenna |
| Turn clockwise to tighten. |
UHF | 75Ω Round Cable Copper Wire |
Antenna | |
| 300Ω Flat Wire |
Single Family Home | Antenna |
| Converter |
UT | ANT IN ( 75 ) |
Antenna Jack
- In poor signal areas, to get better picture qual- ity, install a signal amplifier to the antenna as
shown to the right.
- If signal needs to be split for two TVs, use an VHF antenna signal splitter for connection.
UHF
Signal
Amplifier
NPUT | ANT IN ( 75 |
13