LG Electronics DU-50PY10 Programming the Remote, Programming a code into a remote mode

Programming the Remote

Programming the Remote

GThe remote control is a multi-brand or universal remote control. It can be programmed to operate most remote-controllable devices of other manufacturers.

Note that the remote control may not control all models of other brands.

Programming a code into a remote mode

1.Test your remote control.

To find out whether your remote control can operate the component without programming, turn on the component such as a VCR and press the corresponding MODE button (VCR) on the remote control, while pointing at the component. Test the POWER and CH +/- buttons to see if the component responds properly. If not, the remote requires programming to operate the device.

2.Turn on the component to be programmed, then press the corresponding MODE button on the remote control.

3.Press the MENU and MUTE buttons simultaneously, the remote control is ready to be programmed for the code.

4.There are two ways to find the right code for the component.

A.If you press the CH +/- buttons repeatedly, the codes will change one at-a-time. Press the POWER button after each code change. If the right code is found, the device will turn off.

B.Enter a code number using the number buttons on the remote. Programming code numbers for the corresponding component can be found on the following pages. Again, if the code is correct, the device will turn off.

5.Press the MENU button to store the code.

6.Test the remote control functions to see if the component responds properly. If not, repeat from step 2.

Owner’s Manual 87