LG Electronics 1930 owner manual FCC Notice

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions in the litera- ture accompanying the appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

 

 

 

CAUTION

 

 

 

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Image 3
Contents LCD TV Page FCC Notice Important Safety Instructions Safety InstructionsDisconnecting Device from Mains Exposed to dripping or splashing and noGrounding Contents External Control Through RS-232C Clock SettingOn Disposal Accessories PreparationPreparation Input Menu Enter Volume Channel Front Panel InformationButton + Buttons Menu Button Volume +Buttons Enter ButtonImage shown may differ from your TV Back Panel InformationPreparation Audio OUT Audio RGB/DVIANTENNA/CABLE Digital Audio OUT OpticalAssemble the TV as shown Stand InstallationCushioned surface to protect the screen from damage Stand Body Cover BaseHow to remove Cable ManagementConnect the cables as necessary Vesa Wall Mounting Desktop Pedestal InstallationProtection Cover Protection CoverHinge Body Insert the Protection Cover into the TVScrew Provided as parts of the product Attaching the TV to a Desk Only 26LG30Antenna Analog or Digital Antenna or Cable ConnectionHow to use External Equipment SetupHD Receiver Setup How to connect45.00 60.00 1920x1080i 33.72 59.94 External Equipment Setup480p 44.9645.00 60.00 Hdmi ConnectionConnect the digital set-top box to HDMI/DVI Jack on the TV HDMI-DTVOr 3 jack on the TV Connect the digital set-top box to HDMI/DVI IN1DVI to Hdmi Connection 19/22LG30, 19/22LG31 26LG30 DVD SetupVideo Connection External Equipment SetupHdmi Connection Antenna Connection VCR SetupComposite RCA Connection Antenna Cable Udio You can listen to the sound through the headphone Other A/V Source Setup Only 26LG30Analog DigitalConnect audio outputs to the TV’s Audio OUT jacks VGA D-Sub 15 pin Connection PC SetupAudio RGB/DVI 59.94 800x600 Only RGB-PC mode720x400 640x480Select Screen RGB-PC Screen Setup for PC modeSelecting Resolution Select ResolutionYes Auto ConfigureSelect Auto config Can adjust the Position, S i z e or PhaseAdjustment for screen Position, Size, and Phase Enter Select Reset Screen Reset Reset to original factory valuesRemote Control Functions Watching TV / Channel ControlWatching TV / Channel Control Flashbk Installing BatteriesVolume Adjustment Turning on TVChannel Selection Control Quick MenuSelect Home Mode Initial SettingMode setting Time settingYou can also adjust Initial Setting in the Option menu Option settingAuto Tuning Start Auto TuningFor USAFor Canada ON-SCREEN Menus SelectionWatching TV / Channel ControlChannel Setup Auto Scan Auto TuningAuto Tuning Watching TV Add/Delete Channel Manual TuningSelect Manual Tuning Manual TuningChannel Edit Channel EditingInput List With using Option menu With using Input button Input LabelInput Label Picture Control Picture Size Aspect Ratio ControlPicture Control Set by program Sport, or Game Preset Picture SettingsPicture Mode Preset Are not adjustableColor Tone Preset MediumAdvanced Control Select Backlight, Contrast, Brightness Manual Picture AdjustmentPicture Mode User Mode PictureOff Picture Improvement TechnologyLow Advanced Control Black Darkness LevelMenu Select Picture Select BlackAdvanced Control EYE Care Only 26LG30 Advanced Control Advanced Control Gamma Advanced Control Real CinemaReset Picture ResetSelect Reset Initialize the adjusted valueSelect Power Indicator Power IndicatorMenu Select Option Auto Volume Off Balance Sound & Language ControlSound & Language Control Preset Sound Settings Sound Mode SoundLanguage Control Sound Setting Adjustment User Mode Select Balance BalanceTV Speaker Off Turn the TV speakers off if using external audio equipmentAudio Reset STEREO/SAP Broadcast Setup Analog TVDigital TV Audio Language Select Option Select Language Select AudioLanguage English English Menu ON-SCREEN Menus Language Selection Menus can be shown on the screen in the selected languageLanguage English Text Caption ModeAnalog Broadcasting System Captions CaptionDigital Broadcasting System Captions Select CC1-4, Text1-4, or Service1Caption Option Digital OptionCustom G Time Setting Time SettingClock Setting Auto Clock SetupManual Clock Setup Return to the previous menu Return to TV viewingClock Feb/21/2008 F Manual Auto ON/OFF Time Setting SettingTime Sleep Timer Setting Sleep Time turns the TV off at the preset timeSleep Timer Off Auto SHUT-OFF Setting Auto Sleep OffAuto Sleep Chip rating and categories SET Password & Lock SystemSetting up Your Password Parental Control / RatingsParental Control / Rating Select Lock Input the password Select Lock SystemIs enable Lock SystemSet Password Set PasswordChange the password by inputting a new password twice Input the password Select Set passwordBlock Channel Channel BlockingMovie & TV Rating Movie Rating Mpaa Only for USAControl / Rating TV Rating-Children Age TV Rating Children Only for USATV-PG, TV-14, TV-MA TV Rating General Only for USASelect block options TV-PG,TV-14TV Rating English Only for Canada Selecting canadian english language rating systemTV Rating-English Select E, G, 8ans+, 13ans+ TV Rating French Only for CanadaSelecting canadian french language rating system ParentalDownloadable Rating Downloadable RatingEnables you to block an input External Input BlockingInput Block KEY Lock Return to TV viewing While viewing the TVKey Lock Off Appendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixVertical bar or stripe on Background Picture OK & No sound No output from one SpeakersExtended Absence MaintenanceCleaning the Screen Cleaning the CabinetModels Product SpecificationsRS-232C Setup Communication ParametersGND Set ID RS-232C ConfigurationsEither cable below can be used RXD TXD GND DTR DSR RTS CTSTransmission / Receiving Protocol Command Reference ListSet ID DataCr Data 00 Lock off Data 01 Lock on Step Version 2, June GNU General Public License101 102 103 GNU Lesser General Public License 105 106 107 108 Mozilla Public License 110 111 112 113