Onkyo Optimize Your Sound Experience with TX-NR1008 Receiver

Using Dipole Speakers

You can use dipole speakers for the surround and surround back speakers. Dipole speakers output the same sound in two directions.

Dipole speakers typically have an arrow printed on them to indicate how they should be positioned. The surround dipole speakers should be positioned so that their arrows point toward the TV/screen, while the surround back dipole speak- ers should be positioned so that their arrows point toward each other, as shown.

ab Front speakers

cCenter speaker

de Surround speakers

fSubwoofer(s)

gh Surround back speakers ij Front high speakers kl Front wide speakers

Dipole speakers		Normal speakers
i	j		i	j

f	TV/screen			f	f	TV/screen		f
k	a	c	b	l	k	a c	b	l

d		e d	e
g	h	g	h

Connecting Powered Subwoofers

Using a suitable cable, connect the AV receiver’s SUBWOOFER PRE OUT jack to an input on your powered subwoofer, as shown. If your sub- woofer is unpowered and you’re using an external amplifier, connect the SUBWOOFER PRE OUT jack to an input on the amp.

You can connect the powered subwoofer with two SUBWOOFER PRE OUT jacks respectively. The same signal is output from each jack.

Powered subwoofer

LINE INPUT

LINE INPUT

Bi-amping the Front Speakers

The FRONT L/R and SURR BACK L/R terminal posts can be used with front speakers and surround back speakers respec- tively, or bi-amped to provide separate tweeter and woofer feeds for a pair of front speakers that support bi-amping, providing improved bass and treble performance.

•When bi-amping is used, the AV receiver is able to drive up to a 7.1 speaker system in the main room.

•For bi-amping, the FRONT L/R terminal posts connect to the front speakers’ woofer terminals; the SURR BACK L/R ter- minal posts connect to the front speakers’ tweeter terminals.

•Once you’ve completed the bi-amping connections shown below and turned on the AV receiver, you must set the “Speakers Type(Front)” setting to “Bi-Amp” to enable bi- amping (➔ 47).

RightLeft

speakerspeaker

Tweeter (high)

Woofer (low)

Important:

• When making the bi-amping connections, be sure to remove the jumper bars that link the speakers’ tweeter (high) and woofer (low)

terminals.	En
• Bi-amping can be used only with speakers that support bi-amping. Refer to your speaker manual.
	15