Onkyo TX-NR1008 instruction manual Changing “Monitor Out” setting manually, Resolution

Changing “Monitor Out” setting manually

1 Press MONITOR OUT on the front panel.

The current setting is displayed.

2 Press MONITOR OUT on the AV receiver repeatedly to select:

`Analog, HDMI Main, HDMI Sub, Both, Both(Main) or Both(Sub)

For details on each item, in the “Monitor Out” settings (➔ 43).

■Resolution

You can specify the output resolution for the HDMI output and COMPONENT VIDEO MONITOR OUT and have the AV receiver upconvert the picture resolution as neces- sary to match the resolution supported by your TV.

`Through*1:

Select this to pass video through the AV receiver at the same resolution and with no conversion.

`Auto*2:

Select this to have the AV receiver automatically convert video at resolutions not supported by your TV.

`480p (480p/576p):

Select this for 480p or 576p output and video con- version as necessary.

`720p:

Select this for 720p output and video conversion as necessary.

`1080i:

Select this for 1080i output and video conversion as necessary.

`1080p*2:

Select this for 1080p output and video conversion as necessary.

`Source:

Output will be according to the resolution level which was set in the “Picture Adjust” setting (➔ 54).

Tip

•The “Resolution” setting is set respectively of main, sub, and analog.

Note

•If the “Monitor Out” setting is set to “Both”, this setting is fixed at “Auto”.

*1	PC IN (Analog RGB) input signal is output at 720p resolution
	when the “Monitor Out” setting is set to “Analog” (➔ 44)
	and the “Resolution” setting is set to “Through”.
*2	These settings are not available when the “Monitor Out” set-
	ting is set to “Analog”.

En

44