Onkyo TX-NR1008 Multi Zone, Connecting Zone, Connecting Your Zone 2 Speakers to an Amp in Zone

Multi Zone

In addition to your main listening room, you can also enjoy playback in the other room, or as we call Multi Zone. And, you can select a different source for each room.

Connecting Zone 2

There are two ways you can connect Zone 2 speakers:

1.Connect them directly to the AV receiver.

2.Connect them to an amp in Zone 2.

Connecting Your Zone 2 Speakers Directly to the AV receiver

This setup allows 7.1-channel playback in your main room and 2-channel stereo playback in Zone 2, with a different source in each room. This is called Powered Zone 2, as the Zone 2 speakers are powered by the AV receiver. Note that when Powered Zone 2 is turned off, you can enjoy 9.1- channel playback in your main room.

To use this setup, you must set the “Powered Zone2” setting to “Act” (➔ 75).

Hookup

• Connect your Zone 2 speakers to the AV receiver’s FRONT

WIDE/ZONE 2 L/R terminals.

Main room

TV

AV receiver

Zone 2

RL

Note

•With this setup, the Zone 2 volume is controlled by the AV receiver.

•Powered Zone 2 cannot be used if “Speakers Type(Front)” is set to “Bi-Amp” (➔ 47).

Connecting Your Zone 2 Speakers to an Amp in Zone 2

This setup allows 9.1-channel playback in your main lis- tening room and 2-channel stereo playback in Zone 2, with a different source in each room.

Hookup

•Use an RCA audio cable to connect the AV receiver’s ZONE 2 PRE OUT L/R jacks to an analog audio input on your Zone 2 amp.

•Connect your Zone 2 speakers to the speaker terminals on your Zone 2 amp.

Main room

TV

AV receiver

Zone 2
	IN
R	L
Receiver/
integrated amp
Note

•With the default settings, the Zone 2 volume must be set on the Zone 2 amp. If your Zone 2 amp has no volume control, set the “Zone2 Out” setting to “Variable” so that you can set the Zone 2 volume on the AV receiver (➔ 75).

Zone 2 12V Trigger

When Zone 2 is turned on, the output from the ZONE 2 12V TRIGGER OUT goes high (+12 volts, 150 milliam- peres max). Connecting this jack to a 12-volt trigger input on a component in Zone 2 will make that component turn on or off as and when Zone 2 is turned on or off on the AV receiver.

En

73