Onkyo TX-NR1008 instruction manual Dhcp

4 Use qw/ to select the setting, and use er/ to set them.

To enter an IP address, select the setting, and then press ENTER. The arrow can then be used to enter numbers. Press ENTER again to set the number. The settings are explained below.

5 When you’ve finished, press RETURN.

The save confirmation screen appears.

7-6. Network

Save

Cancel

6 Use q/wto select “Save”, and then press ENTER.

When modifying network settings, after modifying it is necessary to execute “Save”.

7 When you’ve finished, press SETUP.

The setup menu closes.

Note

•This procedure can also be performed on the AV receiver by using SETUP, arrows, and ENTER.

■Mac Address

This is the AV receiver’s MAC (Media Access Control) address. This address cannot be changed.

■DHCP

This setting determines whether or not the AV receiver uses DHCP to automatically configure its IP Address, Subnet Mask, Gateway, and DNS Server settings.

`Enable:

DHCP enabled.

`Disable:

DHCP disabled.

If you select “Disable”, you must configure the “IP Address”, “Subnet Mask”, “Gateway”, and “DNS Server” settings yourself.

■IP Address

If you set the “DHCP” setting to “Disable”, you must specify an IP address. Enter a static IP address provided by your ISP.

The IP address must be within the following ranges.

`Class A:

10.0.0.0to 10.255.255.255

`Class B:

172.16.0.0to 172.31.255.255

`Class C:

192.168.0.0 to 192.168.255.255 Most routers use Class C IP addresses.

■Subnet Mask

If you set the “DHCP” setting to “Disable”, you must specify a subnet mask address.

Enter the subnet mask address provided by your ISP (typi- cally: 255.255.255.0).

■Gateway

If you set the “DHCP” setting to “Disable”, you must specify a gateway address.

En Enter the gateway address provided by your ISP.

■DNS Server

If you set the “DHCP” setting to “Disable”, you must specify a DNS server.

Enter the DNS server addresses provided by your ISP.

■Proxy URL

To use a Web proxy, enter its URL here.

■Proxy Port

If you’re using a Web proxy, enter a proxy port number here.

■Control

This setting enables or disables control over the network.

`Enable:

Control over the network enabled.

`Disable:

Control over the network disabled.

Note

•When set to “Enable”, power consumption on standby mode increases.

■Port Number

This is the network port used for control over the network.

Note

• Set the port number between from “49152” to “65535”.

70